We have the following important tips for using tools： 1-Prep glue pulling tabs by soaking them in 91% rubbing alcohol and drying them before first use. 2-Clean the area to be repaired with 91% isopropyl rubbing alcohol and a clean towel. It is important to remove all wax and grease from the surface to insure the glue and dent pulling tabs properly adhere to the damaged area. 3-Apply the glue pulling tab to the exact center of the dent. Avoid applying too much pressure when placing the dent pulling tab to the dented area, so you do not create too thin of a layer of glue between the car panel and the pulling tab. 4-Allow the glue to set for about 5 minutes prior to using any glue pulling tool. The glue should be hard to the touch at the time you begin repair. If your fingernail leaves an impression in glue, simply allow a couple more minutes for glue to harden. Keep the panel to be repaired out of the direct sunlight so the glue will set properly. 5-It is common for the dent pulling tab to release from the glue, leaving the glue on the panel of the vehicle. When this occurs, spray 91% rubbing alcohol on the edge of the glue and peel it away using the plastic scraper. 6-You may need to repeat steps until the desired result is achieved. It is not uncommon to repeat the process up to times. 7-Occasionally a high spot is created when pulling the dent. If this were to happen, gently tap down any high spots using the dent hammer and the plastic tap down tool provided, until the dent is flush. Be careful not to tap to hard or you might create additional low spots. Kit Includes: 1XDent Lifter 1XDent Bridge Puller 1XLined Dent Board 1XPDR Hammer 1XAluminum Tap Down 1XGlue Gun 100W 48XPuller Tabs 5XYellow PDR Glue Sticks 1XTool Bags 1XGlue Scraper
Trustpilot
1 day ago
2 weeks ago
