This is a 3/4" Tank Adapter with a 1/2" nickel plated brass easy action DOUBLE lever tap at the other end. It comes with a snap-on fitting to the first outlet suitable for use with standard garden hose and a 3/4" BSP male thread to the second outlet. It can be used with any tank or drum to provide a fully adjustable on/off tap. With this item you can convert any suitable container into a Water butt or simply add a new or second tap where ever required. FITTING Firstly, you will need to drill a hole (25 / 27 mm diameter) where you want to locate the item. Important.....You must be able to get your hand into the tank or drum somewhere close to enable tightening of the back nut. You will also need to make sure that the area where the hole is being drilled is reasonably flat. You will not get a good watertight seal on a heavily curved surface (a slight contour will be OK). Once you have drilled the hole, remove the back nut and rubber sealing washer from the adapter and push the threaded section through the hole. Then push the rubber sealing washer back over the threaded section and finish by screwing home the back nut as tight as you can by hand. Do not overtighten.
R**L
Excellent tap. I think it is meant for larger ...
Excellent tap. I think it is meant for larger water butts than those found in gardens as its weight might be an issue for the thinner plastic types but cannot fault it. One the sturdiest around.
Trustpilot
2 months ago
1 month ago