Bonviee 106.5FT Drip Irrigation Kit, Garden Watering System with 12-Port Irrigation Manifold, 1/2 inch Irrigation Tube and 1/4 inch Blank Distribution Tubing, Automatic Irrigation Equipment Set for

I found the system incredibly easy to install, and the instructions easy to understand. Follow them and you will too! Ignore them and you will have issues like hoses popping off. I have 4 of these systems installed in both my container veggies and my planted beds, and absolutely zero problems. I used warm water to heat the 1/4 tubing prior to installing on the manifold and sprayer heads per the instructions. Truly could not have been easier or more cost effective for my needs. Will buy more if I expand my garden. Not sure if I need to bring inside during the winter or if draining is sufficient.

Wanted an easy way to water plants on my deck. Very easy to install. I added an automatic timer and the plants are doing great. Good bang for the buck.

I got this when I was going on a trip and asked my family to water my plants. It's fairly easy to set up. The only issue I had was getting the tubing to attach to the connectors. It is much easier to have a cup of boiled water with you to soak the pieces so they stretch. Works well, though if you don't get the connections together tightly, the tubing will come off and water will spray everywhere. I had one set up in my small garden and bought some more tubing to trail some to some potted plants.

Wife and I have a planter pot garden. Bought this kit to keep our crops watered while we were on vacation.Assembly is very easy, and straight forward. I was able to bury the ¼ lines under our flower beds' ground cover, and the manifold under our hose reel. Makes for a neater looking install.You'll need to disconnect the manifold from.the emitter lines, and bring it inside in winter. I'm fairly certain freezing water inside would break the manifold easily. But otherwise both have sat out all summer so far without a problem.Pros:So easy. No tees, plugging end of runs, etc..Water pressure is consistent on all line runs at the same timeThe Y-adapter for the hose bib is solid brass construction (at least on my kit), and not a cheap plastic one.Cons:You will likely use MUCH more ¼ line than you might expect. This is because each emitter is on its own line. The included line was not enought for 1 manifold, much less 2, so I bought a 656ft length.Making plugs for the unused manifold ports is a bit of a pain.You'll need to buy a timer unless uou plan on manually turning the emitters on and off.The supply line is a bit short IMO. But if you have some old garden hose then you can simply make your own.Also I wish the emitter ports were arranged around the circumference of the manifold rather than off the top. This would make it much easier to bury the lines under flower bed mulch/gravel. As is there's a considerable messy looking mass of hose lines coming out of the top. Also it makes it difficult to plug unused ports.

Love this! Exactly what I needed for my garden what is the ground and low instead of hitting the leaves and spraying all out of the garden. Many choices with the layout and choices with the type of spray to come out just love it! Great value for the money