zipelo Brake Bleeder Hose, Universal Clutch One Way Valve Tube Bleeding Tool, Hydraulic Brake Fluid Bleeder Replacement Hose, Vehicle Repair Accessories for Brake Bleeding & Hydraulic Clutch Systems

Used this little device so I could install a new clutch slave cylinder and bleed it myself. Opened the bleeder nut, installed the inlet hose of this device onto the bleeder nut, and then just pumped the clutch until the clutch/brake fluid came out without bubbles. The slave was full of fluid with no air so I closed the bleeder nut, added more fluid to the reservoir and all done! Just be sure not to pump too much fluid before adding more to the reservoir or you might allow air into the top of the system (master cylinder). This little device worked so well that I think I will use this another day to drain and replace all of my clutch/brake fluid as scheduled maintenance. Note, the clear PVC tubing that comes with this is very stiff so I used some that was more flexible and fit over the bleed nut nipple better.

This worked great! My aprilia mille is supposed to be very difficult to bleed the clutch. I accidentally let a bunch of air in the system my first time with a different bleeder and this one pulled out all the air bubbles in no time! It fixed my clutch issues! Definitely buy one and give it a try!

brake bleeder and check valve, Now you can bleed your braked without help from others. you are really paying for the check valve as there is not much to the clear plastic hose. this device works and is reusable.

The hoses are way to small. Absolutely will not fit the brake bleeder nipple

Excelente producto

The 2 hoses are different inner diameter. The one u put on the bleeder screw is too small and cannot put in bleeder screw. Had to cut other one and use that with a clamp. Not the best thing but it worked in a pinch

THIS IS OK. BUT JUST USE A PIECE OF 3/16 HOSE AND DRILL A HOLE IN A PLASTIC BOTTLE CAP AND PUT THE HOSE IN AND PUT ABOUT TWO INCHES OF BRAKE FLUID IN THE BOTTLE AND RUN THE HOSE TO THE BOTTOM AND BLEED YOUR BRAKES. YOU'LL BE FINE. BUYER BE WARE. IT ISN'T JUNK IT'S JUST NOT NEEDED

Bought this for my Cbr600rr the small hose is too small to fit over the fitting on the caliper and the large hose is too big to connect directly and too small to fit over the one way valve. I could not use this at all.