80 Pieces Soft Cutting Board Rubber Feet with Stainless Steel Screws, 0.28 x 0.59 (HD), Soft, Non Slip, Non Marking, Anti-Skid, Fine Grips for Furniture, Electronics and Appliances

Used for grippy feet on small free standing wooden shelves on my kitchen units.

They are exactly as described and would work well for a smaller chopping board but I will need to find a larger version as I need feet to go on a solid oak board the size of a sink cut out and the weight / size will be too much for these.

Well I've brought a new chopping board and it is a bit flat on the work top and that's why I brought these, great sturdy feet and makes it so easy to pick up the chopping board fully recommend it

I had a very good quality wooden board that had lost its feet.These ones are rubber, don't skid, and come with nice short screws.Very good product, and the right item for the job.Fast delivery too...very happy.

The rubber bits come off easily leaving the screw intact on the feet, then you can imagine what that will do to your floor. Useless

These are NOT soft. Shiny semi hard things that dont grip a surface very well - Avoid

Bought these for a diy lamp project to give cable clearance on a wide wooden base. They worked perfectly & are small enough to be easily hidden.The rubber is a medium-hard compound, flexible enough to avoid cracking when screwing on, yet hard enough to provide good stability.They come in a tidy little clear box. I would use these again!

Liked the fact these just the right amount of flex which meant they gripped and did not slip like unlike some I bought that hard plastic and slid about

Make a lot of cutting boards and these are my feet for the boardsGood quality and love stainless screwd

This is a value-pack of little rubber feet and there are probably more included in this set than anybody could possibly need in a lifetime, unless you have a wood shop and are putting these on every product you make. I found it was a better deal to buy this set than a smaller set at about the same price. Plus, I liked the way these attached.... with actual screws. Those screws, however, could be better... they should be pan head screws so that when you tighten the screw, there is no danger of the rubber foot being disengaged and falling off.I bought these to replace the feet on a fancy knife block from a major manufacturer... It always amazes me that you can spend a few hundred dollars on big deal knives and yet they put cheap little rubber feet on the bottom off their knife block. Those were attached with staples (!) and lasted less than two years. These new ones were a perfect replacement. They are better made, quite frankly, and very sturdy and look like they'll hold a long time. Installation was easy with the provided screws. These can be used on cutting boards and knife blocks, as well as furniture and some electronics... as long as there is a wood surface to screw these into, you can use 'em.

These are hard to find where I live and for the price I'm very impressed and would order again.

Used for cutting board. One of the rubber feet was deformed and couldn't use.

The material is really grippy. Also, worthy of note, when the feet slide on the counter (used for a cutting board), they do not leave a black residue trail. The screws are conveniently short enough so that only a poke in the wood with a nail is sufficient, so no drill is needed.