WEAVERGrand Slam Lever Lok Top 1-Inch High Mount Rings

I wanted a set of quick detach rings to mount a scope on my Ruger 10/22 takedown rifle. With a regular (permanently mounted) scope, it wouldn't fit in the short factory carrying bag. With the QD mount, the gun breaks down into three pieces: receiver, barrel, and scope and it all fits in the carry bag nicely. Some reviews commented on the tightening levers not coming to tight in the same position in relation to each other and in relation to the receiver and scope. I had the same issue, but I loosened the levers enough to rotate the tightening nut on the opposite side a little at a time until both levers went tight horizontally parallel to the receiver/scope. Now, when I mount the scope and tighten the levers, they stop in the same position and look good. I have taken the scope off and on several times and can see no appreciable loss of zero. Bearing in mind that this a 22 and the typical ranges are short, it works well for my purposes. I can't speak to how well it would hold zero if it was mounted on a larger caliber, longer distance rifle. Bottom line: I like this mount. It looks good and it works.

I first bought the UTG Medium Quick Detach rings to use with the Vortex Crossfire Scout Scope but found that the scope was too high to the point where I was not able to use it with a proper cheek weld. Then I slapped on a leather cartridge butt cuff from Andy's Leather and it made it slightly better but it was still too high.I then decided to do more research and gambled on these Grand Slams High Mount Rings which judging by reviews I worried that I was either going to get rings that were just as high as the UTG Mediums or be too low to even mount my Vortex.But these are perfect! Low enough to get the scope where I wanted with barely just enough room to still use the scope bikini that came with the Vortex Scout scope.So if you are looking for rings for the scout setup with the vortex this is a Grand Slam... Sorry...

These may be a great product, but they are NOT high rings...... They are in the medium to medium low range. From the top of the receiver to the center of the scope on a set of high rings is about 1.25- 1.5 inches (varying from manufacture to manufacture). From the top of the receiver to the center of these rings is only 13/16ths of an inch.

Useful on a Ruger 10-22 take-down rifle. Cannot use open sights with a rail/base attached to top of receiver. Must use a scope which must come off for rifle parts to go into carry case that came with rifle.

Great Rings, "LITTLE TANKS" , little low for me, I'd get the Really high See through next time. Other thank that, they work great, really can crank down on these and they lock in super tight, all steel, not a cheap Bi Metal like some or aluminum. These will last you until you have grand kids.

These rings mount easily and is a great option for a quick detach. Retains zero well enough for my application on a 30-30 with shots inside 150 yards.

Weaver Grand Slam Leaver Lok is all I use on my scopes. The leaver lock makes it easy to change scopes from one rifle to another. Yes, I have to set my zero again but, if you take notes for each scope-to-rifle zero, you can make any adjustment much easier. Most of the time, after I set the scope to what I have written down, I don't need to adjust anything. I do like these scope rings.

I wanted quick release rings for my AR in 450 bushmaster. Even with high rings I needed a 1/2” riser. Perfect