NEIKO 01925A Screw-Extractor and Left-Hand Drill-Bit Set, HSS M2 Steel Drill Bits, Alloy Spiral Flutes, Reverse Drill-Bit and Bolt Extractor, Easily Remove Stripped Screws and Broken Bolts, 10 Pieces

They work fantastically, i needed to remove the rotor retaining bolt with a sheared head from my car and these worked a treat at boring out a hole and removing the bolts.highly recommended.

This, when used slowly, was able to remove a broken screw from my IKEA office chair. It was just out of its warranty, and using this meant I could replace the screw rather than buying a new chair.It works, so if you have a broken recessed screw, give it a go and see if it works for you.

Product does what it says on the tin - drills not commonly available in UK and I fell into the trap ordering these but not realising they come from the USA . Taxes virtually double the cost (Thanks Royal Mail for your ridiculous handling charges!) but the seller was willing to refund the taxes as their ad failed to mention their locationAs far as useability is concerned - tip - go easy and try warming up the area you are drilling with a torch or hot air gun before drilling / extracting your screw or stud (slowly slowly catchy monkey!)

Two drills snapped on first use. I'm not sure what they are supposed to be made of, but they are brittle and made no impression on some standard wood screws. The extractors are also blunt and ineffective. The metal box design is very poor, the smaller drills drop out and become wedged.This is a cheap and very poor product.

left hand drill bit worked perfectly, managed to drill in to a stud that had snapped ca 10mm inside the head of my engine. As soon as it bit the stud span out with little swarf and no need for the extractor on this occassion. This made a tricky and time consuming job quick and simple.

The drill bits are all cut at the wrong angle so have negative cut (back edge higher than cutting edge) the fluting is designed to remove swarf but with the cutting edge as is, wont cut at all. So suggest sharpening with a bench grinder if you have one.Also the drill bits are NOT cobalt as suggested, they're steel with a titanium coating. So they are not designed to cut stainless steel even if they were sharpened correctly.The extractors are also steel with a titanium coating.

Very good thanks

Thanx