Pinfox Waterproof Electronic ABS Plastic Junction Project Box Enclosure 200mm by 120mm by 75mm (Black)

Caixa em ABS de muita qualidade, material muito bom mesmo.

TL;DR - I've bought 2 of these for homemade music equipment, both turned out great!I use the large boxes (200mm by 120mm by 75mm, black) for DIY electronics projects. Here are the my key takeaways.Good qualities:- The material is easy to drill holes in.- The thickness is perfect for mounting most components (switches, LEDs, potentiometers, power connectors, MIDI connectors, audio jacks, and more)- The nuts that are built into the case for the top are metal and don't wear out if you need to open it repeatedly- Box is very sturdy- The large box has enough space inside for most DIY electronics components, including commonly found PCB boards. (from photo, notice that the PCBs are standing upright and fit without issues)Bad qualities:- The internal standoffs aren't very useful, and get in the way. But they can be snapped off.- The lid is slightly curved, and the curve gets worse if you use the waterproofing seal. It would have been great if the case had 6 screws instead of 4- The outer surfaces easily scratch (from fingernails or tools). Handle carefully!Recommendations:- I use DeWalt titanium drill bits and a conventional hand drill to make holes.- Use a small drill bit to make a guide hole first before making the larger hole.- After drill, the edges of the holes/cuts tend to be jagged, I recommend using washers or component mounts with a flange to cover the imperfections. (From the photo, notice the mounts for the LEDs).- The internal standoffs can easily be snapped off using large pliers.- Simple rubber friction feet work great for preventing it from moving around if sitting on a smooth surface- Unless you need water proofing, I do not recommend using the waterproof seal. It causes the lid to curve when screwed in. The lid is perfectly snug without it.I've purchased other boxes of different dimensions from the same supplier. The smaller boxes DO NOT exhibit the same curving issue with the lid. Even then, I still give the box 5 stars as the curve is not really noticeable at a distance, and does not effect its use if you are not putting other devices on top.

I have my standing desk on casters and I like to move it around my office from time to time (to change things up). Because of this, I have extra cable coiled up under my desk and I wanted a way to keep it tidy. So I drilled holes in either side of this box so that i could pass in cables in one end, coiled them up, and pass them out the other (I used rubber grommets to pretty up the holes). This way I could adjust how much power and ethernet cable I pulled out for the current location and the rest was hidden away on the lower shelf blending in. I don't have a picture of it installed, but this fit the bill.

My only complaint about this casing was the placement of the small stubouts on the inside, which I assume must be for supporting it structurally. Other than that, these are very good casings.

Good for electronic projects.