Temporary Power Outlet Panel with 20, 30, and 50-Amp Receptacle Installed,RV Electrical Outlet Panel with Breaker

It's been in use for the past fourteen moit's pretty much a very good quality for the money and value way cheaper than lowe's or home depot

The product is made with very cheap plastic and cheap wiring within the first four month's I had to replace the receptacle after that zip-tie dried out and cracked causing the ground to Short circuit almost causing a fire.

Great setup! Ability to add brakers is why I bought this.

This thing comes with 3 receptacles. (one 220v and two 110v) Also comes with 3 breakers (50A, 30A & 20A) It's completely wired and ready to power up. That's the good news. Bad news is there are some things to do before you can use it. 1) none of the bus bars have screws in the empty positions. You need to buy some M5 X 0.8 machine screws for your grounds on the bus.. 2) The neutral is not bonded. There is a ground screw but you have to buy a ground strap and the neutral bus isn't standard height. 3) By far the biggest pain is the Hub. The hole pattern is off just enough to not fit a normal Hub. May-be another brand would fit but I used a GE 1 in. water tight Hub and the holes didn't line up. I drilled the Hub mounting holes out with a 3/8 inch drill bit to get the screws to fit. I used four M5 X 2.0 screws with washers and lock washers to mount the Hub (see pic) It comes with a water tight Hub gasket. 4) there's only one mounting hole in back so you might want to drill a couple more. Good luck

Item was complete. Grounding buss bar is attached with wire ties????Was going to move it and mount properly but left it alone.It us doing what it is supposed to do.

I installed an RV pad in my yard in this box is very convenient as it has all the plugs so if at a later date, you change campers, he will still have the proper plug.It was the cheapest one I could find, and on the box it says made in China but for a change I was impressed with the quality

Failed in less than 2 years. Cables melted and breakers fried.

Breakers came cracked and broken. Hot wires to the 50 amp outlet are 2 different sizes and undersized for current draw. Neutral bus bar is zip tied in place not screwed. No extra screws in neutral or ground bus bar to connect wire or add circuits. The knockouts at the bottom are only 2 sizes so had to drill an additional hole of the appropriate size to connect. Extremely disappointing and unsafe. If I had it to do over I would have spent a couple more dollars on a decent panel.