MNA Top Bearing Flush Trimming Bits Set of 4, Straight Flush Trimming Router Bits Set. 1/4" shank. Cut to heights of 1/4", 5/16", 3/8", 1/2". Ideal for trimming shelf edges etc. (Send Bearing)

good value for the price. I am a scenery carpenter and have used them several hours a day for the past week. As hard as any bit you can buy, amazingly after cutting 18mm plywood all week they as still pretty sharp and going strong. The only thing I have noticed is a little variation in size, but it is very minimal and common even with bits that cost the same as all 4 of these.

Used this bit set to make a mortise for tea lites in drift wood. I needed long bits because of my scaffold and nature of the wood. These did the job wonderfully and I’m very pleased. It’s hard to find bits this long and fit good reason because they are more dangers to use so please be careful.I will say one bad thing though: these bits were not the best for plunge routing. They were slow and got very hot during this process. Otherwise they were great.

The flush trim router bits was exactly what i have been needing. While the company is based in America the bits were made in China, a previous bit i was using kicked back on me, theae are antikick back so my fingers are breathing a sigh of relief tonight. The spare parts included with the bits are an added bonus. If a bearing was to fail i don't have to stop what I'm doing to go out and buy a new one.

These are my first router bits. I’m practicing with these and will get more bits as funds allow. Use pliers or gloves the first time you take the bits out the blades are sharp. Now I just need a scrap wood source.

So far I used one, it worked well. Trimming 3/4” plywood.

Did The Trick

Good quality

i had high hopes as ive used there other products, it " worked " for my project .cutting in mortises forbench vises, however the tolerences on the cutters were kinda sloppy and blades not really sharp enough for oak..lesson learned ..not horrible, but certainly not great