Firecore 4-inch Wide Air Chisel Bit, 0.401 Inch Shank Tile & Thinset Scaling Chisel Thinset Scraper Wall and Floor Scraper Tile Remover Work with Air Hammer (4" X 7.5")

Worked great with my existing air chisel to remove ceramic tile from a floor for a bathroom remodel. I only needed it for this project but the cost was reasonable and it seems durable.

Easy to use on the air hammer. good for removal of sheet floor covering on concrete. easy removal of ceramic floor tile. For replacing broken floor tiles, removes the thin set adhesive.

Worked great to remove tile

It is just what I expected

Finally had a chance to use this bit in my air hammer/chisel cleaning the sludge off the bottom of my CNC Plasma water table. The metal cut by the plasma cutter hardens and sticks together if I don't clean out my water table very often and this easily broke it up and scraped it off the bottom making for easy cleanup. It also cleaned off the slats nicely as well. I like the width of it as well for doing jobs like this.

Trabaja muy bien.

I was impressed by it's durability. 300 sq/ft of fortified thinset cleanup didn't dull the edge. I would recommend it.

Worked well for chipping up tile, good tool well-made.

I bought this to use for 12" x 12" ceramic tile removal and I am very happy with the performance. This single "spatula", easily removed all the tile and the mass majority of cement, over an area of 240 sqft. That is a serious plus when I look at what I paid for it. Amazingly, there is still alot of life left in this thing, by the looks of it. I would not hesititate to recommend this to any of my friends, based on my experience with it.

With a small air hamer and a 2hp compressor I managed to clear the tiles from a Kitchen prior to replastering it. Also good at lifting floor tiles. Shame i had to import it from the USA

I bought it to clean off some tiles and thinset/mortor off my basement floor after I had a major plumbing drain line repaired under the concrete basement floor. One thing I found was that you're distributing the air hammer force across 4" so it was a little tough to run. I found it was better to make a lot of 3/4" passes in the thinset/mortor then use this 4" blade to clean up what was left.

Works perfectly

C'est un burin de très bonne qualité.