Mr. Pen- Cable Clips, 30 Pack, Black, Adhesive Cord Organizer, Cable Organizer, Wire Organizer, Cord Holder for Desk, Cable Holder, Wire Clips, Cord Keeper, Desk Cord Organizer, Cord Clip, Wire Holder

I use these in my vehicle to make my multiple phone and various cables nice and tidy. I suggest applying them and letting them set for a few hours before putting the wires in. They have held up in the heat and cold. Make sure you clean the surface and you will have great success with adhesion. The clips can fit up to 3 smaller wires which is a plus and they look nice and sleek. They even work for thicker wires like my solar.

Bought these to get a microphone cable out of the way underneath my desk. I prepped the surface by wiping it down with rubbing alcohol then letting it air dry. I used six of them for the run of cable that was being supported. Some difficulty in removing the backing on a few of the clips. The adhesive was so strong that the backing wanted to stick, unless you managed to lift it up in the right spot. Be careful when placing them, because you’re not really going to get a chance to readjust them. When placing, I pressed on each on for about 30 seconds. A month in, I haven’t had any issues with them losing adhesion.

Good enought for lighter cables.

good product

I am kind of OCD over cable management and these work well for that purpose. Each can handle 1 USB type cable or 1 cable that is power and ground like a lamp. Not good for thick cables like a monitor or PSU. So they are small. However the adhesion is great as long as you clean the surface with alcohol or something. I would rate it 100X better than that Gorilla double stick poly crap. You won't go wrong with these as long as you don't expect it to do too much, pay attention to the measurements.

Good for flat surfaces such as metal or plastic. Not so good for textured surfaces. You get a lot of them for the price. I mainly needed these for under desk organization which worked great when applied to the metal desk legs. I tried using these for dash cam cable management in my vehicle but the adhesive was not working. Scraped off the adhesive it came with and replaced it with 3M permant tape, which worked great! The removal of the plastic tabs on the adhesive can be tricky to remove so use twizers if possible! Depending on which type of surface you are applying these to, your results will vary.

I use these to string wires when installing dash cams. They even stick to some Plastics in vehicles known for still having mold release residue on the plastic which causes most sticky items not to stick

Wanted to use these to secure the usb cables from my GPS and GPS speedometer to the dash. First the backing is extremely hard to get off the adhesive on the clip. I cleaned the dash with rubbing alcohol, let it dry and then pressed on a clip holding it in place for awhile. Put the usb cable in the clip and the clip immediately fell off of the dash. This happened with 4 clips.