The D12 is a simple deliquescent compressed air dryer for 100 CFM. It's designed to remove harmful moisture from any air system using up to a 25 horsepower air compressor. The dryer has no moving parts or power requirement, which makes it perfect for tough operating environments, such as Ready-Mix and asphalt plants, sawmills, lumber yards, and anywhere with a lot of dust. The D12 is also great for intermittent use air systems, point of use applications, mobile equipment, and areas with electrical restrictions. The D12 consists of an epoxy lined tank filled with Dry-O-Lite desiccant tablets. Wet air enters the bottom of the tank and flows up through these tablets, which absorb water vapor and slowly dissolve. Liquid collects at the bottom of the tank to be drained. Compressed air exits the top of the tank. An F200-100 or equivalent filter should be installed immediately after the dryer to remove oil mist and particulates. Clean dry air is now ready for use. The benefit of the D12 relative to other drying technologies is the simplicity. There are no moving parts or power requirements. Installation is also simple. Just connect air lines and add Dry-O-Lite desiccant tablets. No special skills are needed for maintenance. Drain liquid from the tank after each 8 hours of operation. A manual ball valve is included. Pro tip: use flexible tubing to collect the liquid in a container and consider installing a full-ported automatic drain with a 1/2" valve, such as the Van Air Systems MDV-400. Every 2-3 months inspect the dryer's Dry-O-Lite level by looking thru the sight glass on the side of the tank. Top off the tank with new Dry-O-Lite tablets as necessary. A D12 dryer will consume approximately 130 lbs. of Dry-O-Lite desiccant per 2000 hours operation at peak flow (100 CFM).
Trustpilot
3 weeks ago
2 months ago
