SYLVANIA9003 ZEVO® LED Headlight Bulbs, 2-pk

son luces muy buenas y estan diseñadas como el foco H4 original en el sentido de que no deslumbra a los conductores que tienes al frente (solo con las altas) cambia mucho el campo de visión no son como los leds Chinos que lanzan el haz de luz para todos lados menos para donde debe de ser, los recomiendo los utilice en un ford ikon 2015, un ford figo 2019 y en una frontier 2015

If installing this on a 2009 Tacoma, don’t mess around and fight with the limited space, especially with the larger overall length of bulbs. On passenger side, remove the two bolts holding the washer fluid reservoir, gently pull up and tilt towards firewall. This provides lots of additional room to work on passenger side. Remove the battery tie down on driver side so you can shift/ tilt battery back to make enough room for driver side bulb.Once that’s done, pop female connector off bulb with a small flathead screwdriver. No clips to bend etc. Then pull off rubber bulb seal the same way using a small screwdriver to pop it out. Undo spring clip holding bulb in place by pushing toward front of truck, much like a safety pin in concept. Then, remove existing bulb. Next take tri-blade run bulb adapter off new led bulb from box, and put into headlight housing. The big tab goes at top, and then push spring clip back in. Then pop bulb seal back onto housing by pushing in on outside diameter, then the inner ring to ensure its seated in/on new adapter ring. Install new bulb with cord at bottom, push into bulb seal and turn slightly to lock bulb into adapter. The reconnect wires like you would an extension cord. Repeat same process on driver side.While the instructions call out most of the above, they don’t tell you how to make room for the slightly longer overall bulbs and heat-sinks.Now, I wait for dark to see if improvement over 12 year old OEM bulbs.

Looks like a good upgrade, but unfortunately does not fit my 2008 Honda CRV without major effort and surgery to vehicle which I am not prepared to do. It is impossible to install on the driver’s side headlamp without removing major car components first or removing the entire headlight assembly because of the tight space behind the bulb.

Esta muy bien, pero le falta mas claridad, pero para Ciudad esta bien.