15-19 KAWASAKI MULEPROFXT: KFI Winch Mount

Item fit perfectly on my 2017 Kawasaki Pro FXT. I mounted a Harbor Freight 5000# Badland winch that fit in the opening perfectly. The only thing you need to be aware of if you mount this same configuration is the rear post(yellow) on the winch touches the plastic frame guard(see pic) and will not allow you to remove the post bolt once the winch has been tightened down. Rather than remove the winch to put on the cable I cut a notch in the ring terminal and converted it to a spade connector that I could slip on before tightening. I would suggest you to put the cable on the post before you mount the winch. I would also think about filing the post down about a 1/16" to gain a little bit of clearance because over the years the post might rub through the plastic and short out on the frame. I am very happy with the product. Hope this helps.

I installed it n a 2019 mule fx pro. It with a bad land 2500lb. It worked fine

Mount worked perfect on my FXT mule. I set mine up a little different than most. I mounted a 3500# receiver on it so i could slide a mobile winch into the receiver. Works great. The mount is strong and works perfect this way.

Sturdy and fairly easy to install

Did need to drill some different holes for my winch, but not an issue as my winch was not on the compatible list. Mounted to my 2016 Pro DX just fine. They has a good set of instructions if you need it. Shipped very quickly and packaged well. No problems.

This is machined extremely well. It's made of thick metal and everything lines up perfectly. I used a 4000lb winch from tractor supply.

All welds and holes are perfectly placed !! Fits great on my FXT Pro.

Working