AUTOXBERT 38cm/15 Inch Hand Sewing Steering Wheel Cover Breathable Anti-Slip Leather Steering Wheel Cover for Nissan Qashqai Toyota Camry RAV4 VW Golf

This is in our 4 runner. It looks great and took about 40 minutes to stitch. Keeping the string tight did cut one of my fingers so maybe wearing gloves would help. But aside from that it turned out nice.

Muy util

This said micro leather, so I expected a thinner piece of leather with a backing of some sort but this not leather at all. is exactly what you would expect from plastic “leather”. The thread to stitch it up with is the same “floss” you use for cross stitching. Not quality at all. I didn’t even put it on my car I ordered from another company that was solid leather

First thing I will say is do NOT double..meaning pull it through the needle to a halfway point and tie the 2 ends in a knot, if you do this you will not have enough thread!First one I ordered I "doubled" the thread how I would normally hand sew anything (ZERO INSTRUCTIONS PROVIDED WITH THIS ITEM)and I ran exactly a half steering wheel short.. imagine my frustration after spending at least a half hour stitching this thing on only to run short by HALF of the wheel.Forced to cut it all off I contacted Amazon about not being provided enough thread, they sent a replacement. When installing the replacement I only put the thread through the needle just enough to hold it and didn't double it over on itself, this time I actually had some extra thread left over once completed.Some vehicles you might be able to double it over and still have enough but not on my particular vehicle.Looks and feels very nice once installedTime will tell how long it lasts.

Awesome

Overall, I like the feel of the product. The stitching was already loose when I started. So I had to make some adjustments to get it to work if the stitching had been complete. And yeah, thicker, I would have given it a five star bit, and that's current state.They needed a little bit more hardinessOverall, I like the feel of the product. The stitching was already loose when I started. So I had to make some adjustments to get it to work if the stitching had been complete. And yeah, thicker, I would have given it a five star, but in its current state, it needed a little bit more hardiness

Nice steering wheel cover. Has a nice feel and looks good. Only recommendation, take your time at the start. I got about 4”-5” of sewing done before I realized I was doing it wrong. None the less, nice product and I would recommend.

I was pleased with the quality of the leather and the thread and was excited because I could tell it was going to look good once I got going. It takes a little bit longer than you’d expect to sew it, and unless you’re a squirrel then it’s kinda a chore navigating around about the wheel so it’s not without effort. Got the whole top section and 2 of the 3 lower sections complete and ran out of thread with the last lower small section to go. All of that work making sure it was perfect only to not have enough two cent thread to finish. Now I gotta cut it all out and return it bc they don’t even sell the extra thread. You would think that they would give you more than enough considering it can’t cost that much and would save everyone the hassle of wasting their time and money. Would rather pay a few more dollars to get 10 cents worth of thread extra to know I’ll get the job done. So I suggest looking at other options and check the reviews to make sure there’s no “not enough thread” comments. Unfortunately I didn’t and now I see it is an issue for a lot of the customers here.