Scotty PeelerLabel & Sticker Remover - SP-2 Metal Blade with Protective Cover (Set of 2)

This is wonderful for removing any stickers from items purchased at stores. Once you use it, you’ll never go back. No more breaking my nails or chipping my polish trying to remove stickers.

Works great at my job for scraping labels. Watch your fi fingers, very sharp.

I use tis for work and it is excellent.

Would definitely buy again.

I use these to remove prints from my 3D print bed. If you do the same, make sure to round the corners or they will easily dig into your print bed surface. I use PEI and kapton tape mostly. Tip: Use alcohol to remove the prints. I don't force my prints off the PEI or any other surface (BuildTak, Elmers on glass, Zebra Plate, etc.) with the Scotty Peeler. I place alcohol around the circumference and let capillary force pull it under the print and the part will float free in a few minutes -- sometimes more. If the part does not float free, I do force the edge of the Scotty Peeler under the print just a small bit and that catalyzes the capillary action to occur. I find that PLA can make such a snug bond to the surface that alcohol cannot get under it without the use of the Scotty Peeler. Large ABS prints and ASA prints must be squished into the surface so they do not warp/lift during printing. ONe of these prints an be so stuck you will think you have to destroy the plate to get it off. You don't. Alcohol and the Peeler will save everything with almost no force needed.

It does the job.

Easy to use, but leave your finger far away, it can cut if slip.

I've found out that I can use these for box cutters, peelers, cut out and remove labels from cardboard. They have become so versatile!