Rain Bird MSDSSTK Drip Irrigation Down Spray on Riser Stake, 360° Full Circle Pattern

10 ft spray radius is more like 6 ft

The product is good and works fine as designed. it is a nice package with 1/4 inch pipe attached with connector to connect to 1/2 pipe after making the hole. It does save time to directly punch hole and use it to install. The spray itself works fine for the intended purpose. I use it to spray my garden grass as i have a small area and using a traditional sprinkler if usually overkill and sprays too much and this was the ideal solution. The product is good but kind of expensive as compared to Home Depot, which is selling microspray on a stake for less than $2, although it does not have the 1/4 pvc attached.So would advise to weigh options and if all in one package is desired, this is a pretty good solution

I may be using these wrong, but I've not achieved good coverage with these. They either spray too far (a ring section instead of a circle section) or too close (a tiny circle section), and this is with good water pressure. They also seem to produce large droplets that are not very evenly distributed. Also, some of the 90 degree heads don't quite cover 90 degrees, more like 70.You need good water pressure. A single 1/4" line can only run one of these, so you'll need to plumb a 1/2 distribution close enough (unlike normal drip emitters where I can almost water my whole 250 square feet with one 1/4 line).I wound up replacing the heads with the bulk micro spray heads from Home Depot (which produce mist instead, and that works better for my needs).

Best sprinkler yet

It doesn’t spray as shown in the picture. It is more of pouring around 5 inches radius. I tried the adjust the knob still same thing