GeeekPi Acrylic Raspberry Pi 4 Case with 4010 Blue LED Fan + Heatsinks + Extension Board for Raspberry Pi 4 Model B

The media could not be loaded. It's perfect, the annoying thing about the pi has always been that the cables fo everywhere and you end up with a twisted rats nest on your desk. That is no longer the case!Fits my pis without any problem, tested with 3b and 4b (although they're all the same size anyway).The daughterboard is perfect, the case is reasonably easy to assemble, fan is silent, and I haven't experienced any problems with thermals.Brilliant case and extension board!

+ Case is very nice. It's protected by a layer of brown paper that's easy to remove once you can find an edge.+ You can connect the fan directly to the 5v pins on the far side of the expansion board. No need to use the GPIO pins.+ Fan is pretty quiet. Not silent, but you can't hear it over ambient noise.+ Between the fan and the heatsinks, the temps on my Pi 4 under normal use is very acceptable. Some reviews mention heat management to be poor, however they are overclocking their Pi to 2GHz - only someone who didn't know what they were doing would expect this kit to manage this level of strain. If you are overclocking your Pi, you cannot rely on a 5v fan and adhesive heatsinks to reduce your temps low enough. This is basic knowledge and it's unfair to criticise this setup for it.- GPIO slot is pretty high and the Pi fits in very snug. You may need a height extender to feed a GPIO ribbon out of the case without putting pressure on the pins.- The expansion board adds a USB port. There's no documentation on what this port is for, however from looking at the board it appears to have a power connection only.- The fan doesn't come with a guard so it's pretty exposed.All in all, pretty happy with this.

A great case, well manufactured and easy to assemble. Having all of the ports on the rear tidies the desktop nicely. The included fan cools the pi more than adequately under normal loads even when overclocked. The only attribute to be aware of is the thickness of the acrylic can make the micro SD card a little difficult to extract but this is less of a problem now USB booting is supported.

The product was ok apart from the badly soldered audio socket plug which was at an angle, making it impossible to fit the Raspberry Pi. However, 20 minutes with a hot soldering iron fixed hat.It was this product or the Argon One; I chose the geeek product becasue it had two full size HDMIs and space inside for other items.

Easy to put together and looks really good with a good quality fan.Bang for buck!! Recommend A++++

i like it.this was recommended by ETA prime on YouTube he also suggested covering the top with vinal which i did .as well as taking all ports to the back it has full sized HDMI sockets which are not so fragile.and i think it looks like a piece of art !

Very nice and practical case for my raspberry pi 4

looks neat and tidy all the cables are on the one side of the case easy to put together