BUCKLOS 26/27.5/29 MTB Suspension Fork Travel 100mm, 28.6mm Straight Tube QR 9mm Crown Lockout Aluminum Alloy XC Mountain Bike Front Forks

I bought this fork (29") to replace the fork on a Schwinn Twinn tandem bicycle. The Schwinn comes with a 26" tire, but the factory suspension fork allows the pedals to be way too close to the ground. I was tired of banging pedals and cranks on almost every turn. I bought these 29" Bucklos forks, which fit great and keep my pedals at a much better height, no more concerns with ground clearance now. An added bonus... these Bucklos' perform better than the factory Schwinn forks. Suspension movement is smooth and can be locked out and perform as a rigid fork if desired. The Bucklos decals didn't stay attached and kept peeling up, so I removed them without leaving any sticky residue behind. I think these are a great affordable fork option and I would buy them again!

Worked perfectly to replace my wife's forks.

the product is good except for the quality as ids I needed this urgently now I am up the creek

I took all the measurements first and for the 700C Schwinn Glenwood I chose the 27.5" forks. That is the correct choice. The Crown Race on the old forks had to be taken off and put on the new forks. There is no lower race on these forks. You would buy a 30mm ID Crown Race for these forks if you are installing a new one. This is a straight steering tube 28.6mm except for at the bottom where the Crown Race is installed. The forks work just fine. The steering tube was slightly longer and I prepared for that by buying a spacer kit on Amazon for cheap. I added only about 8mm of spacer to get the stem about 3/8" above the steering tube to start so that the top cap could be tightened and the forks could be adjusted correctly. The other thing you need is a new star installed in the steering tube. I had the Crown Race taken off the old forks and reinstalled on the new forks as well as the star installation done at the local bike shop. For that labor they charged me $29. They had the right tools and did it quick. The star was $5.00. Very nice forks. No rocking and clicking like the stock Glenwood forks which are junk with the plastic bushings worn out from the factory. These new forks actually work like forks. Tighten or loosen the preload so that the forks sag about 20% when you are sitting on the bike.

These low cost forks are worth every penny. Bought 1 then another after I saw how decent they were.