Phoenix goods V Belt Adjustable Link V-Belt - 1/2-inches x 4-feet A/4L Type A Link Belt

I like the belt. It was easy to change to take out three or four pieces to make small to fit in machine.

Only recently, installed this belt, therefore durability can't be addressed properly. It does appear worthy at present. The destructions could be better, but the process is not rocket science, therefore, you'll become comfortable with it and easily figure it out on your own.My goal was a reduction of vibration on an old Band Saw. Coupled with a new Pulley, this was accomplished to a very noticeable degree. It definitely helped me on my way to a smooth saw. Thanks

I bought the belt for my old contractor table saw. What a revelation! I should have done this years ago. The saw is smoother, quieter and much nicer to use! The belt was easy to fit and adjust for correct length which turned out to be slightly shorter than the original v belt. If you are still reading this - why - go buy one….

The instruction were complicated......I just want to know how much tension there should be in the belt for a table saw. I needed an engineering degree to understand the instructions. I put the belt on and then by trial kept removing links from the belt until it seemed to work well with the saw. Pretty tiny little picture in the instructions are fairly useless to understand how to remove and reattached links but again by trial and error I removed 3 links to get a good fit on the table saw. Each time I ran the saw for a few seconds the belt seemed to loosen up. I used a pair of needle nose which were a big help in pulling the tabs through

Quiet. A little stiff but I assume the links will loosen a bit. Runs my saw amoothly