WEILAILIFEUniversal Bullet Camera Junction Box (8 Packs)

Professional design

For three of my interior cameras, I modified regular electrical boxes from Home Depot, drilling holes in the face plate to fish in wires and mount the cameras, then painting them house colors instead of gray. But for the eight cameras that were going outside, I REALLY didn't want to do that much work. These fit the bill almost perfectly, and I wish I'd gone looking for them sooner.Overall they're sturdy in the hand, seemingly made of good materials. (I guess time will tell on that... being out in the Las Vegas sun will certainly put them to the test.)The center holes and their removeable plugs made wire placement easy, however I did have to cut my removeable center plugs so that they would wrap around my wires, rather than pulling the wires through the hole. But that's because I had a big honkin network connector that simply wouldn't fit through the plug hole.One puzzling thing was the camera mounting holes on the faceplates, which took a minute to wrap my head around. These appear to be designed to fit about eighty thousand styles of camera, with mounting holes all over the faceplate. At first I was annoyed thinking that the holes penetrated the faceplates and made them swiss cheese, but they didn't, they're only partial holes. My particular cameras sat a little low-of-center on the faceplate, which gave me minor concerns of possible water seepage into the center hole. But after mounting everything and looking it over, I'm confident water won't be an issue. (This has not been tested yet though.)The one negative I can give these is that there's only two punchouts for conduit to attach. This might not seem like a big deal, but depending on where your conduit is going to run, (left, right, top, bottom), it makes a difference because of the way the faceplate mounts to the body. Because the faceplates already have holes to mount the cameras, and because the faceplates only mount to the body in a certain orientation, that could be problematic to someone depending on how the body needs to be mounted to accept their conduit. In my case it wasn't an issue because I had conduit coming into the bottom, but for someone else I think it could be.All in all it's a good product though, and I have no buyer's remorse.

Excellent

Fits my Swann cameras thanks!

I purchased these to provide a way to mount my cameras easily, have the ability to remove cameras easily and keep Ethernet cabling protected. The cover offers a large amount of threaded camera mounting hole configurations. The cover comes with a gasket and mounting screws. The construction is very nice and well built. It comes in white, which is what I wanted, but I imagine you can spray paint it to a color that matches the surrounding colors. I would highly recommend this for a clean and professional looking install.Install:For a solid mounting surface, I added 2x6 wood block above soffits and drilled a 1" hole through blocking. I attached the junction box to blocking. The soffit material was cut to fit around the junction box and I caulked around the junction box to weather seal.Bullet Cameras:Most bullet cameras I have seen, allow you to adjust pitch but not always horizontal angle when mounting to a soffit. Before installing, I suggest you figure out the mounting hole configuration for your cameras and temporarily mount camera to understand camera position relative to the junction box mounting position. This will allow you to figure out horizontal angle of the camera (4 positions depending how you attach cover.