Lian Li O11Dmini-1 Vertical Gpu Bracket Kit /Pcie 3.0 / Black -O11Dmini-1X-3

Fit like a glove and was a great alternative to a third party vertical mount. This does mount the GPU a little higher than i would like but still plenty of clearance with an AIO cooler installed. Also enabled me to install a couple of fans at the base of the 011 Mini for more direct airflow to the GPU. PCI-E cable was just the perfect length as well. Another quality accessory from Lian Li!

Fits my O11 mini air case, and it would fit the O11 dynamic mini aswell, you can adjust the gpu bracket 3x to fit your cpu cooler so its quite flexible. And no need to remove the MB to replace the old back panel. Easy instal.

Pros:*Very easy to install in a O11 mini - literally takes 2 minutes*Thumb screws only for install*Leaves the bottom two PCIe slots open on a full size ATX mobo, which is nice*Has slots in the bottom plate for more airflow to the GPU*Overall is pretty secure and solid when installed properly, my GPU sits nice and level*GPU fans sit at least 2 inches from the side glass (and thats with a 3 slot GPU), plenty of room for cooling. I have already confirmed no change in temps for my GPU.*Bridge cable appears to be decent quality and is also flexible enough to move around a little.Cons:*If you have a current gen GPU (RTX 4000 series in particular) you are definitely going to lose the rear fan slot - look at my pic (thats an MSI gaming trio RTX 4070ti). The rear fan doesn't even come close to fitting with my GPU. I could install the fan on the outside of the case, that is actually an option and there is a slot to get the fan wires back through into the case, but I'm not sure yet if I want to do that or how it would look.*One of the tabs on the left side of the mount (that interlocks with the case) is located where the mobo I/O shield is. This shouldn't be there because it actually interferes with installation. I had to flatten it out with pliers to get it to install correctly. I guess it would install right if you put this mount in BEFORE your motherboard install, but otherwise it doesn't.*Its expensive for what it is. There are a lot of whole cases that don't cost this much. But if you have a O11 mini and you like the look, its worth having the one that is made specifically for this case.NOTE: Depending on your GPU you may have to loosen the little screws holding the PCIe port down to the bottom plate, mine was too far back and the GPU wouldn't mount up properly. For a second I thought it wasn't going to fit, but luckily the port position can be slid forward/backward by a few millimeters as needed.

This is very well made and works on the Lian Li O11D Mini and the O11 Air Mini.

Helaas is de doos gedeukt en daardoor ook het metalen frame

Très bien pour sa carte graphique , surtout sur les founder édition ou l'air sort sur le côté , mais le problème c'est que je peux pas mettre de vis pour attacher ma carte graphique , impossible l'espace et trop grand comme montre la 3eme photos