SKF99187 Speedi Sleeve and Tool Kit, Inch, 1.872in Shaft Diameter, 0.563in Width

Purchased this for my 73 F250 to use with the new rear pinion seal. It fit like a glove and did exactly what I was hoping it would. Compared to similar items on the market, the price was spot on. I would definitely buy one again and highly recommend this one.

These are great. Use a micrometer to check your axle before ordering - you can get a good inexpensive micrometers here on Amazon.I installed it by pushing it into place with a PVC pipe; no need for mallets, hammers or presses. No more leaks.

Did lots of research looking for just the right part. Site said it'd fit. Does not fit. Return window closed... (that part is my fault, I should have worked on the vehicle sooner)

We used PN 99187 Speedi-Sleeve (1.873"-1.878") to repair the seal surface on the Dana 44 rear axle shafts of our 2004 Jeep Wrangler Rubicon, and it worked great using the simple instructions that were included. The only issue was finding a tube to drive the Sleeve into place, because the included "installation tool" can only be used on short shafts (not on a 28" long axle shaft). But as luck would have it, a tree had fallen and destroyed our Costco 10' x 20' canopy, but we were able to salvage one of the main upright posts that just happened to have the perfect internal diameter to install the Speedi-Sleeve (every dark cloud has a silver lining?).

Price was right, shipping was fast and the sleeve was easy to install. It worked perfectly!

Front output shaft of my NP208F Transfer Case was leaking on my 1981 Bronco. Perfect fit for the yoke. Cured it.

Said it was verified to fit my 1998 chevy silverado but was too small and did not fit!

Fit the yoke perfectly on my 69 Charger with a 742 case 10 spline pinion.