MP-03AL

Worked perfect on my M&P 2.0 45 cal

if you’re looking for an easy solution that doesn’t involve hundreds of dollars to pay for someone to mail your slide and the risks that come with that this is an amazing product. The customer support is fantastic as well. As someone who finally took the plunge to get a reflex on one of my pistols and knew nothing about the process, they were extremely helpful with explaining everything to me and helping me make the right decision when it came to which models to purchase a hint, especially with advising me to have a gunsmith do the actual install of it. In the end between the cost of the Smith installing and bore sighting the reflex for me, I was all in for less than 80 bucks. If I’d had the slide milled I would’ve been looking at at least 200 to 250. The only downside is it sits slightly higher than it wood on a mill slide, but after two trips to the range for practice, I was used to the sight picture and it wasn’t an issue at all.

This is a perfect fit for the Dovetail on my Next Level Training SIRT PP (Pocket Pistol). It slid right in with the same resistance as the sight that I pushed out, and it holds tight. It fits all my RMSc footprint sights without issue. So, if you have a SIRT PP, this is the mount you need to add an optic.

Product was exactly as described and the instructions for installation were spot on. Installed and topped with a Holosun 507k, ten minutes on the range and I was up and running! 100 rounds later still spot on unit worked amazing and sits on top of my EDC. Great option for the non-optic cut slides.

Good quality

Easy to install. Used on mp 22 full size. The extra weight with optic causes malfunctions but a supressor adds proper back pressure and functions great.

Fits just right on the SD9VE, had a holosun green dot on it and its great! Pretty heavy duty.

Despite what the ad and the packaging says, it is not titanium but aluminum. A mistake that should be rectified. The plate fits very tightly, barely hangs out past the edges of the slide and is sized perfectly to my Holosun 507K. It also fits my Alien Gear holsters. If you are new to pistol mounted red dots as I am be aware that this combo will not co-witness the stock front sight which really slows down red dot acquisition time. This is common with 99% of these plates across all the mnfrs. If you want that 1% setup, dovemounts, they can be found here as well. But then you run into holster fit issues.