Zixtec 20 Pair 30AMP Quick Disconnect Power Terminals Connectors, Red Black Quick Connect Battery Connector Modular Power Connectors Set…

I've tried a few different brand/makes of power pole clones on Amazon and these are the first advertised as "30amp" that actually have terminals that accept the 12ga wire needed for 12v 30amp power.

Fine for non-critical systems / bench wiring. Definitely not 100% the same as genuine powerpoles, and wouldn't necessarily expect them to interoperate perfectly. That being said, they're wonderfully cheap and I'll gladly continue using them.

1. They connect fine with my Anderson and other non Anderson connectors.2. They slide together nice with no biting. As good as Anderson and definitely better than others.3. I had no problem using the proper gauge wire with each connector. No melting as I use the correct wire size and length needed properly address the amperage/current.Seriously, the proper length and size wire cannot be overstated. Use the online calculator at Wirebarn and remember the length is shows in the calculator is one way (one wire), as the ground would typically be at the chassis near the component. If you are going to run both positive and negative wires the same length, you need to take that into account and divide by two.

Perfect on specified GA. wires works best in combo with heat shrink at wire ends to.Even Useable with standard crimp ratching pliers also with smaller wires ability to solder in . These kits do not have an extraction hook tool something that should be with all power pole kits.Bottom line Works.

Mates perfectly with my existing Anderson connectors. Well made. I’d buy these again in a flash.