Gas Can Spout Replacement Improved Design Flexible Pour Nozzle Kit with Gasket Stopper Vent Cap Collar Caps for Old Style Water Gas Container Jug Pack of 3

Does the job as it should. As it turns out I have two five gallon jugs that each require a different thread, but this kit has both, so that was great. The valve for the back of side of the jug was a breeze to install and works great. The only issue I have with the kit at all was that the nozzle is a bit smallish for my taste, and the cap doesn't stay attached when you unscrew it and start to pour fuel. It tends to either fall off, or be in the way. I've gotten in the habbit of just taking it off completely and laying it aside, but it would be good if they'd make the retainer strap longer and make it fit tighter to the nozzle so it stays attached. But over all it works exactly as I'd hoped as far as pouring fuel into implements. I'd recommend it.

Good quality for Chinese stuff. Fit well. Used on gas and kerosene cans.

The only problem I see is the don’t have a washer with a screen and the 3 caps don’t match / fit well. They have a coarse thread and the spout has a very fine thread.

Good

Junk. Plastic cracked after few months, leaking gas, first from nozzle then, from the "cap". I had to replace the nozzle and cap 3 times from just one gas jug... Fresh out of the bag, they were good but, not made for harshness of gasoline.

These spouts work and fit as expected. You need a 1/2" drill bit to insert the vent. Easy-peasey. The issue I have is the small caps for the end of the spouts is a course thread, but the spouts ends are fine threads and will not seal. Luckily the spouts kits come flat caps to seal the gas cans without the spout.

I live in Kalifornia, and you just can’t buy a gas can nozzle here without it being one of those jobs that HAS TO HAVE a button you push, prior to pulling the nozzle back (like you are cocking a gun) so that it can dispense fuel. The springs always break, leaving the nozzle inoperable. Prior to the spring breaking they start to leak, which is contradictory to the whole idea of these “Cali approved” nozzles which are “supposed” to cut down on spills, fume pollution, etc. I ordered this kit, fixed my 2 inoperable cans and have been enjoying them ever since. It’s crazy I haven’t spilled a drop since getting these, but was constantly spilling gas with the crappy “Cali approved, environmentally safe” nozzles. This is a serious upgrade.

They are great, gas runs so much better. plus the hole to allow air did the trick. The original container was terrible and caused gas to spill out and took for ever to fill tank in engine.