Nilight Headlight Assembly for 1999 2000 2001 2002 Chevy Silverado 1500 1500HD 2500 2500HD 3500 Chevrolet Tahoe Suburban Replacement Headlamp Housing Bumper Lights Set

Easy to install. Good quality. Teamed with a good LED headlight it is super bright.

Arrived this morning and installed this morning. 2003 Chevy Tahoe. Easy install, takes about 20 minutes total to remove the old and install the new. Crystal clear, very bright with my Sylvania ZXE Gold bulbs, beautiful transformation, really improves the look of my truck, perfect fitment, no gaps anywhere, tight fit. I would definitely recommend these light assemblies to anyone needing some great lights and if ever needed I would definitely buy them again. Tips: Before installation, adjust the up/down screws in until they are about 1/2 an inch long, they are set too far back from the factory and will make it seem as though they aren't going to fit. Disconnect your bulbs and place the bulbs in the assembly then, connect your harness back up, the low beam bulb fitment is very tight and will be hard to connect with the harness on. Be sure to check daytime running and signal assembly and make sure you have the correct lights for the side that you are getting ready to put on, they will fit bavkwards but you'll notice it's really tight and will have a bad gap (Ask me how I know😂) Overall I am 200% satisfied with this purchase. The fog lights were purchased 2 years ago from Topscope, they still look great and perform great.

The lights are a snug fit, however, the clip broke off under little pressure. Very disappointed in the product. The headlights are great. I will never buy this item again.

These headlight assemblies are very clear and bright. They were a little tricky getting in place, but with some fanagling I finally got them seated so I could slide in the holding rods. One of the adjuster blocks broke and I got a replacement. The common complaint with these assemblies is the lateral and elevation adjustments don’t work or break, and that was the case with my first set. All the brands seem to have this issue. So here’s my work around in the second set: I used super glue (jb weld would be better) on the adjustment screw anchor point and beefed up the plastic mounting point. The adjustment screw is very rough and poorly machined, and that contributed to the first adjusters breaking. So I used silicone oil on the screws, and dripped some into the jackscrew block mechanism. I also marked the direction for each adjusting nut so as to avoid any unnecessary turns. And lastly, I was very gentle adjusting the elevation and lateral movements. It all seemed to work out. I’m probably like a lot of you and resent having to do diy on new products, but the alternative to these $85 lights are OEM at $400-nuff said!

Fit well on my 2002 Silverado 1500 LS.

They was easy to put in

The First set of Light I received didn’t fit the clips on Running lights were to short, did a refund/ replacementSecond's Set of Lights for replacement never deliveredSo called Amazon they sent 3rd Set of lights received them 48hrs after I calledOn this package One Headlight was stripped completely and both of running/ parking lights were the only thing that fit SMH!So used headlights from first set and parking lights from 3rd setTo make a super great pair of headlights

I have had 8 different brands of headlights over the years these cast the light as good as stock lights but look way better. Great flow of light with out any hot spots or light casting too far to the left or right. Very surprised with the quality and performance.

Los faros se ven de calidad sencilla, pero en cuanto a el funcionamiento alumbran muy bien