LED Submersible Trailer Tail Lights, Under 80" Combo Stop, Turn and Tail Functions with License Plate (Made in the USA)

A piece of junk for 2 reasons, and I can't remember when I was SO disappointed in view of the largely great reviews others have written about it. The lesser issue is that when I tested the one that worked (to see if it's worth the effort to argue with the company), they were not as bright as the incandescent bulbs originally on my trailer, both in running and brake/turn modes. But most important is that the other lamp just fell apart as took it out of the bubble wrap from the box. Examination revealed that there were supposed to be four locking tabs (they're supposed to hold the actual lamp to a largely hollow housing), but two (on the same side) were broken off (one of the pieces was in the box, but not the other -- did it break before it was boxed?), allowing it to just fall apart. And since these locking tabs are under tension, they can't be glued back on. So it's worthless crap. Don't even think of buying it.

Bought these last fall, just got around yesterday (June) to swapping them for the factory ones that came on my utility trailer (had a hard time keeping bulbs working in those.) Easy swap, the wire colors are marked on the back of each lamp and are the same as the factory ones (different on each side). Plenty of wire to make the swap. I used some heat shrink tubing to seal and a small tie-wrap on each side to take up the excess. They look good and should eliminate the hassle of replacing bulbs or, worse yet, not having any when I'm away from civilizaton, such as at my cabin in WV.

Read all the reviews and agree with the positive and negative ones. Because:Pro:LEDColor wires match up identically, easy installMade in the USA, well builtBright, but...... (Con section)Con:Side LED marker is one dim light, takes a minute to convince it exist.Like other review, lights are very dim at an acute side angle.It does work, no headache install, made in the USA. I would buy again, but look at other options.

I'll try to upload the photos. The lights seem well built, but upon turning them on, it seems like they were made on a Friday. The LED which is supposed to light the side marker portion of the light appears to be installed facing the wrong way. It faces the rear instead of the side marker. The side marker emits no light.I do like the ease of installation and like I said they seem durable. I will most likely return these, contact the seller, and ask them to visually inspect another set of these. Hopefully, this is just a fluke.

These trailer lights have attractive lenses, have multiple LED's inside that provide good illumination, and were easy to install in place of my existing old bulb type lights. They are new on my trailer so I can't comment on their durability yet, but they appear well made and I am satisfied with this purchase

Guilty of marking this low to make sure you know that the side marker lights - as mentioned in the text - are NOT lit. They are just reflectors.I am not sure if this meets DOT requirements but they certainly aren't a directly equivalent replacement for the common cheapo trailer lights most of us are replacing.I have had to order another product just to get the side marker I need. They are bright though and appear as well made as the aisian competitors.I will probably use these as secondaries.

When they arrived, one light didnt work, i was immediately sent a replacement. they are awesome and work well under water.

there is no way these are completely water not to mention bees building nest in the one with tag light there's no cover over the bottom completely open water and bees will fill it up