Maple Veneer 8" x 8", 7-Piece

Nice looking veneer! I'll be using for making fingerboards. Only slightly warped.

I was looking for a wood laminate that I could send through an inkjet printer and this works perfectly!! It rolls in the correct direction and I've made six or seven prints onto them- with only one or two jams- but not enough to break the printer fortunately.

My son bought this to make homemade finger boards with. Works perfectly, and he loves it.

The only drawback I had was the size was 1/4” too short in the grain direction, but I knew that going in. The color I stained it to match the rest of the wood I used was very close. I used contact cement to adhere it to the ends of a fireplace mantel I built and it worked very well.

Had an order of 10 sheets as I needed them for a wedding. I’m using the cricut maker for this project with a completely new needle to carve out the veneer. Every single sheet is warped. I CANNOT go for a stronger pressure on the machine without the sheet completely being torn apart. Even on a regular setting, the sheets still crack and break. Not as much but it’s definitely something I have to sit and watch to make sure it doesn’t completely ruin the piece. Takes well to ink, fine point and marker. Just upset I’ve ruined my 3 strong mats. Also, all pieces are crooked. You either get a tiny bit less than 8in or a tiny bit more but never in a straight line on either ends… I guess for any future costumers I’m going to have to up the price and just buy the cricut veneer to make sure I have a good flat, straight quality veneer.Photos would be shared but Amazon never allows me to upload them so getting my money back. Not worth it.

I ordered this veneer to use on a table top. Many of the pieces had ripples in them and were thinner than the table's original veneer, making them extremely difficult to use. If I had to buy veneer again, I'd make sure it was thicker.

It breaks very easily

This looks like good quality stuff, but it was not what I was looking for - sent it back