Voodonalafor Jeep JL LED Fender Marker Lights, Side Turn Signal Lamp LED Amber Blinker Turn Signal Lights for 2018-2022 Jeep Wrangler JL JLU Gladiator JT, Smoke Lens 2pcs

This product is a great value for the price. I order the lights and installed them the next day. This is how I installed them. I removed the vents. I used three plastic tools at the same time, I didn't care about breaking the clips. I didn't want to damageor bend the metal. I then partially pulled the rear of the wheel well plastic liner down for access to wiring. to do this I removed the center bolt and the rear bolt to the liner. I then removed five plastic rivets toward the rear of the liner and five rivets holding the liner to the fender. These were removed from the back half of the fender well assembly This sounds like a lot of work but it isn't. Amazon sells the rivet's with the clip removal tool for a reasonable price. Pulling down the liner from the rear exposes the wires you need to splice into and allows for easy access to them. Ther are several ways to connect the wires. I have large hands so I extended the Lenths of the wires on the light using 18 gauge wire about a foot. I cleaned the light installation sight thoroughly. Do not take the tape off the light until you check were you will run the wires. You will see were to feed them through. Also if you push down too hard on the light the clips won't grab properly. After finding the fit your happy with pull the tape, feed the wire, and set the light. Note: you will see the wiring to splice in plain view. I wanted directional light so I, T-tapped the jeep green and white wire with the light red wire. I, T-tapped the black ground wire with the red and black light wire. I did some wire clean up then reinstalled the well liner with new plastic rivets.. this a moderately easy installation if you take your time. I am very pleased with the lights, They added safety they provide when turning way exceed the time for install. I hope this is useful.

Easy to install with minimal knowledge, just watch a couple YouTube videos on how to remove the fender. Use a test light to figure out which wire is for your turn signal and splice it in. Before installing stop by your local dealership and grab 8-10 plastic fender clips as you will break a few removing the fenders.

No instructions, hesitant to install, wiring not great.

Good quality and works as expected on 2021 gladiator. The wire is a little short but wax easy to install. You do not heed to remove the fender. Just open up plastic inner wheel cover on my 2021 Jeep gladiator. You can wire to turn signal switch instead but cannot be used for side marker and turn together.. some out there will but 3 times the price. Plastic and fit looks stock.

These are very nice. Install was relative easy as I had the fender liner apart previously to replace the turn signals. I soldered on 18g wire to extend to the jeep harness and used t-taps to tap into the jeep harnessDriver side: green/white for signal, black for groundPassenger side: brown/white for signal, black for ground.Make sure you wire them up and test before you remove the sticky backing. Make sure they work. I had no issues with mine and highly recommend this product.