12awg Silicone Electrical Wire Cable 6 Colors (5ft Each) 12 Gauge Hookup Wires kit Stranded Tinned Copper Wire Flexible and Soft

Each wire is a unique color, so more complicated projects are possible without doubling up colors. These held both crimps and solder joints well. The insulator is a nice feeling material with very low memory, so it is nice to work with. I bought several sizes, and all three are equally high in quality.

Little bigger than I needed, but still got the job done

Good for my brushless motors

No issues

This is high quality wire. Strips and bends really easily. Expensive, but you get what you pay for.

yes, it was useful

Redoing motor wiring? This is the wire to get.. very high quality wire that handles current up to 8s very well for motor wiring.. when I change motors I take the motors I just swapped and go ahead and cut the heat shrink off them and put a fresh run if 120mm of wire back on them so they are ready for another build should I reuse them or they are ready to be sold if I plan to sell them... I hate just joining wires it looks sloppy and adds a point of resistance that isn't needed.. take fresh wire and do it the right way... on closed bottom motors it's harder to do, on the new open bottom stuff and almost everything made now is open bottom it's super easy to do so long as the wires and heat shrink aren't epoxied to the windings on the bottom.. then it can be a bit hard or impossible without causing damage.. in that case you cut the wires fairly close but leave about .75 inches of stripped wire and make a nice clean spliced joint don't just lay the wires over each other and solder together that's a no no.. properly splice them then you will have resistance that is close to if it was a solid place of multistrand wire. I do my wires with red for the middle wire and the two outside wires black.. the reason I do this is in case I'm at a race and don't have time to swap the motor then jump in BLhlei and change motor direction, I just check the way the motor is solder and the red wire helps with that then solder the new motor on and on ready to go. Plus changing the motor direction requires a tad bit more processing in the esc that just isn't needed solder the motors on the correct way and make life a little easier on the esc processor you will have less desyncs on high KV motors if you do this to. It's just better all the way around.

The colors of the individual wires aren't nearly as vibrant as they are in the product photo, but I am able to work with them in my wire stripper, so, small victories. Very flexible, too.

Muy buena calidad y precio para cableados de baterías lipo u otros usos

cumple todos lo requisitos para lo que fue diseñado

Very soft insulation is easy to bend and route around components. Unfortunately, the vendor's delivery service left the package at my neighbor's door in a high crime area. But considering the quality of the wire, I would take a chance and buy it again.

super happy with this product. Really good quality stuff. great price. super soft.. no doubt this is 10awg. fast shipping..

Very happy