Accusize Industrial Tools 1/4'' x 1/4'' x 2-1/2'' (Width x Height x Oal) H.S.S. Plus 5% Cobalt Lathe Tool Bit, 10 Pc Set, 5095-0012X10

holds up nice on my little logan

The media could not be loaded.  I Purchased this 1/2 x 1/2 x 6 HSS with cobalt as it was the go to when making a carbide tool would be more time consuming or costly. I hand ground the tool until I had a 40 degree angle point as I have been doing for 40+ years, then finished with a diamond hone. Once in place, it cut a Poly-V groove into the 5" dia. 6061 T6 alum like butter- Keep the cutting oil flowing too! Choosing the 6 inch tool bit insured it would be held more securely in the tool post holder. 5 stars.

Good price 8" long

Tool was ground to a 45° Lathe tool bit and it does not hold up well to SS.

I’ve been using these for years and I like the idea of being able to resharpen them over and over. In some cases they work better than carbide inserts.

Just ground one of these into a RH tool and turned the rusty crust off of a 1.5" diameter mystery-metal steel shaft. Edge held up well. Grinds and hones well. Seems to be high quality, at least for a hobbiest.

High speed steel used to remove inner weld from square tubing. You can cut it with a cutoff wheel, it tears up bandsaw blades easily

Pierde el filo muy rápido

As a beginner, I think that these tools does the job. I grounded 3 of them so far and used them on brass. Cut like butter ...

Just what I asked for

Won’t be finished making the plane for a few days yet - so no picture! But was just what I was looking for and couldn’t obtain from machine shop web sites, plus once I ordered it was here the very next day. Kudos!

j'ai commencer a couper sur mon tour a métaux avec et ils coupent tres bien. De plus ils on un Côté pré aiguisé a 7 degré d'angle ce qui rend l'affutage plus repide

Arrived and are what I expected