Say goodbye to poorly stored lids and unorganized cabinets! This convenient cabinet rack will have all of your pot lids lined up in one spot to organize your pantry, cupboards, and kitchen. Holds six different sized lids with knobs. Lightweight and easy to install, simply screw lid holder onto the inside of a cabinet, cupboard, pantry, or wall. Make sure to use the appropriate hardware for the job and follow the mounting instructions. Made out of strong iron coated in chrome or white plastic to prevent rust. Measures approximately 9.5 inches Long x 3.25 inches Wide x 16.75 inches Height. To mount on the wall: Use the provided drywall anchors and the long screws to mount. To mount on cabinet door: First measure the height, width and thickness of door to ensure the lid rack will fit properly and to determine the appropriate screw length to use. If the door thickness at mounting site is greater than 1 Inch then use the .75 inch screws. If the door thickness at mounting site is less than .75 inch then use the .5 inch screws (hardware included). If the door thickness at mounting site is less than .5 inch you must use different hardware to prevent cabinet door damage.
B**N
Evelots Topfdeckel-Aufbewahrung-Schranktür/Wand-Organizer,
die Anordnung der Deckelgrößen ist falsch, kleine nach oben, große unten.....so passen nur 3 Deckel rein. Ich habe deshalb alles "umgebogen" und nun ist der kleinste Deckel . Das Material lies sich leicht biegen, dabei ist aber etwas von der Farbe abgesprungen. Ich bin mit "meinem" Ergebnis nun zufrieden.
A**E
Topfdeckelhalter
Der Topfdeckelhalt ist sehr schön,ein Griff und man hat den passendem Deckel zur Hand,immer wieder gern
A**N
Weak welds
Wire welds are extremely anaemic, lowest wire rung was under tension and both welds on one side already have given way.
D**M
Einfach gut
Es ist einfach an zu bauen. Der Preis passt und man hat dann wieder viel Platz.
C**W
Think about the weight when full
It was easy to install in just minutes. I used a couple of strips of permanent tape to hold it in place while I screwed it to the cabinet door. I thought this would also give it some sound proofing. The manufacturer gives you two lengths of screws so you can choose which size is best for your cabinet thickness.It is clunky to get the middle lids out. But I will get use to it. I need to pull down on the one below, then lift the one I want. Otherwise the handles all get caught and they all come out. Mind you these are all huge lids. They overlap.What I didn't consider is the weight of the lids (huge) would keep the cabinet door slightly ajar. I installed a magnetic closer to fix the issue. If you have never used one of the magnetic closer before start with the smaller size. The bigger they are the harder to open the cabinet door. Trust me on this note. LOL
Trustpilot
2 weeks ago
4 days ago