Pypes Performance ExhaustPypes Exhaust HVH13S 3" Diameter Stainless Steel Universal Exhaust Hanger

Quality stainless steel hanger for exhaust systems in the snowbelt with heavy road chemical usage. For use with a 3" system was an added bonus.

5 star product but they are too expensive

Actually used it on 3.5" OT pipe, just replaced the U part. For some reason they don't make 3.5", the largest one I found (and bought) was 3".Well made, solid, highly adjustable hanger.

I just did a complete exhaust system replacement from engine to rear bumper. I wanted it to be secure(like the OE system was) so there would not be rattling, did not want system hanging too low for ground clearance issues, and wanted a good looking as well as a good functioning system. These universal clamps/hangars exceeded my expectations and then some and made my job much easier. If you are looking for a good/universal hangar/clamp that can be compatible the the factory floor pan hooks/hangars, this is an excellent choice. JakePS, I'm a professional tech for a lifetime and this is the type of product I say to my self, that's exactly what I would have tried to make! For the do-it-yourself techs, this will be a blessing when installing exhaust components that are not an exact OE replacement (which have hangars built into the product). In my case, the entire job was custom so this product filled a big hole in the install process.

I ordered these on 26 Sept 21. I finally got around to use them on 3 Dec 21 and found out that they were not 3" as I ordered. Now they can't be used or probably returned for the correct size.

Was relabeled wrong. Actually is for 2.5 inch exhaust. Looks like it's not the first time.

Several months ago, I had a local muffler shop install a Gibson SFT muffler on the aFe exhaust on my QX80. I went to drain and fill the t-case fluid on my truck and noticed they forgot to weld on a hangar on the inlet side of the muffler. This worked perfectly, easy bolt-on installation. All I had to do was cut off the excess threaded rod on the hangar after bolting it all down. Some reviews mentioned the nut(s) backing out so I added some red threadlock for peace of mind.

I bought a used, 2004 Dodge Ram 1500 SLT. The previous owner had the exhaust reworked (flowmaster, sounds great) but the straps were broken, so the pipes bounced around. I had purchased some "universal" straps from my local parts store but once I got under the truck, I knew they wouldn't work.I wasn't sure of my options but while searching to figure out the best way to do it, I ran across an image of these and knew immediately this is what I wanted (a part of the old hanger, the bent metal piece that holds it in place, was still there). I ordered two of these and had them installed in just a few minutes. Nice and secure now. Product is well made, welded steel, will surely last the life of my truck. Definitely would recommend them.

I used this to replace the rotted off hanger on my exhaust pipe near the very rear of my 2012 F150. It works great! Just be sure to tighten it equally on both sides to prevent any stripping or any other issues and you will be just fine!

I thought 5his was a heavy duty clamp. I installed on my truck and its holding for now.I would recommend to use on cars and possibly Suv's

Had to remove original hanger when replacing catalytic on my rv.It did the job and adjustable to get support right.