Flashers #8 Silicone Grey High Temp Flexible Roof Jack Pipe Boot Metal Roofing Pipe Flashing (Pipe OD 7" to 13") - 100% Made in The USA

Fits nice around pipe and flex ring works perfectly on my metal building

This worked perfect for recent edition of the wood stove in my shop. Easy to bend and secure over the corrugated roofing. Love the fact that it is round so the water doesn’t have anywhere to pool on the uphill side as well. Thought the price was a bit much, but it was what I needed to complete the job and about inline with pricing from other manufacturers, so I rolled with it.

I used it for a smoker grille that I made. The stack goes thru a corrugated roof. Worked surprisingly well. No leaks with some high temp silicone

Easy install for wood burning stove pipe. Cut seal slightly smaller than pipe stack hole needed , slide over pipe (use water to make it slide easier), seal bottom with high temp sealant between boot and roof , fasten with hex head screws, clean up excess sealant and you’re done.

This is my 3rd time using one of these on a metal roof, and they work great. Just a word of warning when ordering. Know your roof pitch and how it affects the hole size you will have to cover. The steeper the roof, the more oblong the hole gets. So unless you're installing it on a flat roof, don't buy the one that just fits your pipe. My roof is an 8 pitch, about 35°. The pipe was 8 inches round, and while the hole in the roof was about 8.5 inches wide, it was 10.5 inches long. I went with the next size bigger and it just fit. Two sizes bigger would have been even better, and if the roof pitch was steeper it might even have to bigger still.

very easy installation, cuts easy to fit your pipe size! Highly recommend this product for R paneling metal roof!

Silicone is high temperature just what we needed for gas heater exhaust. Several pipe sizes you can cut to fit your pipe size.

This is a high quality pipe flashing which we purchased to put around a new installation of a stainless steel triple walled wood stove pipe. The roofers cut the metal around the pipe too wide so the base of this flashing did not cover the hole. I ordered the next size up and it fit perfect. Unfortunately this company has a very high restocking fee so we ended up getting refunded about 2/3 of the price we paid. I get that it costs to take products back, however the fee seemed excessive especially since we ordered from them again before making the return. I’d still buy their product in the future as they are family owned and made in the USA, but won’t order in advance when doing future jobs as I own a small remodeling operation and am not used to vendors charging high restocking fees.

Seemed fine, sealed good, till I was not watching my fire and got to hot, now my seal is floating somewhere in the sky. Was good when it was around. The fact I burnt it is not the fault of the seal. I used it on a dual wall heat pipe, I tried to be to cheap and was screwed to a steel roof so gave it a shot. Clearly it did not work. Product still good.

Très satisfait

Came quick and is excellent quality

I installed it on a wood burning stove pipe and it started to crack after a few weeks. Not sure if it’s a quality problem or if I exceeded its temperature rating. This information is hard to find and different sources give conflicting numbers. It has been working for a few months now, and despite some visible surface cracks it hasn’t fallen apart.

Looked like it will work but the silicone became brittle and disintegrated within days