eatelle Vinyl Bulb Translucent Shower Door Seal for 1/4" (6mm) Gap with Pre-Applied 3M Tape, Adhesive Bathroom Seal Strip for 1/4" Thick Glass and UP(3/8, 1/2 Glass) 95 Inch Long

Two major problems with this product. It is basically defective.1) There is a semi-rigid, flat plastic backer (dark pink in the photo) between the gasket and the adhesive. The product was packaged tightly coiled with this layer facing out and the plastic took a permanent coil shaped set. So the gasket curls up off the surface it is adhered to. We tried applying heat with a hair dryer to straighten the plastic out, but it's probably been set in the coil shape for years and difficult to overcome.2) The other problem is the adhesive is very weak and cannot overcome the curling plastic. My guess is the adhesive is beyond it's shelf life as it doesn't even leave any sticky residue as the gasket cleanly peels off (on it's own). Plus it's not cheap. We would ask for a refund but I waited over 30 days to install / discover the issues.

Great adhesive. Exactly as pictured.

All right here's the trick, you have to hang it and let it unfurl, what I did was use a pair of vise grips clipped onto the bottom while it was hanging from the ceiling and then I used the heat gun to warm up the material to remove the memory from the material. Because it's been curled up in a bag and naturally wants to return back to the curled up state. Also the 3M adhesive that is on the back is no good, so I used gorilla glue double-sided clear waterproof adhesive tape.The first time I used this product it failed And I experienced the same failure everybody else was having with it.I did this a week ago and it's still installed flawlessly!

Impossible to keep ends from rolling up. Got two sets, kept unrolled for a week, even used a heat gun on the second set as the first one got wasted as it kept getting unglued at the tips. No change with the second set, keeps ungluing and rolling just a day after install.

Looked for months online and in retail stores for something to use on shower door. THIS IS IT.

We got a new custom shower built and installed these on the edges of the door to fill a small gap so water doesn't get out. I have lots of experience with applying decals and adhesives, so I knew how to ensure this would work. I cleaned the area thoroughly with acetone and it was brand new glass, so there was no chance of a foreign chemical reducing adhesion. I applied this after leaving it rolled and held flat in the sun for a day because it comes in a tight roll.It stuck VERY well in some spots, but the adhesive came off the product in some other spots and stayed stuck to the glass. The adhesive doesn't stick to the rubber. I chalked it up to a bad part and ordered another one. Same deal. This does not work. Don't waster your money.

The adhesive tape does not hold well to the shower glass door. Also wants to re-curl up to its shape in the shipping package. I did fix that by winding it the opposite way and placing it back in the shipping bag, then let it warm up outside in the sun for an hour. Probably would not purchase this again.

The product was curled when I received it. After installation, the two ends were peeled off. Tried several times. Even applied hard force for hours. Still peel off. Had to buy a glue to fix the problem. It does not work as it was described.