SuperATVScratch Resistant Full Windshield for 2021+ Yamaha Wolverine RMAX 2 / RMAX 4 | Easy Installation |1/4" Thick Polycarbonate | Includes Pre-installed Bulb Seal

We really like our windshield. We especially like cruising in our Wolverine with bugs hitting us in the face. I have to say, however, that install for us was difficult. Specifically, we had extreme difficulty with the gasket. Full disclosure, we are 74 and probably lack the strength and dexterity needed to press the gasket onto the windshield. In the end, we were able to get the gasket on the bottom portion of the windshield but did not apply the gasket on the top and sides. We put the windshield on without the gasket and it is still a nice, tight fit with not rattles or whistling when operating the SxS. Overall, a very good product.

I love the full coverage but sometimes miss having a bit of air flow through the cabin of our UTV. We have a Yamaha Rmax 1000 XTR and the windshield does what we need it to do. So far, it seems that it has been resistant to scratches that may have occurred on other less-quality plastics. The top of the windshield does not fit very well between the Yamaha factory roof and rollcage that surrounds the windscreen area. It's not a complaint so much as just an awareness to others. When you are at speed, air flows up and into the cabin through that top gap. I'm going to make a couple small rectangular stainless sheetmetal plates with slots in them and then drill some slots into the very low portion of the windshield to allow for some air flow adjustment to get through when it's hot out.

Fits perfectly on my wolverine X4. For the installation I used a plastic low blow hammer. I found taking the 3 brackets for the roof off helped fit it in more easily.

Easy to install. However, when going 40 to 50 mph the item flexes a lot in the center and vibrates. It causes it to keep popping out of the Yamaha roof channel. I just made a reinforcement bracket at the top to see if it helps long term.

solid, easy to install, custom fit, you will get out of it what you put into it when putting on the black seals around the entire edge and im glad i did.. couldnt fit better, ZERO slippage, no rattaling.. great job.. wife loves it too.. blocks pretty much everything..

Great product and great fit. It took a little doing by myself, but with a second set of hands its not too tough. Best value for the money hands down, and performance is top notch!

Use soap when installing the rubber. At 70 it does bow in a little but still a good product

I tried to press the bulb seal on like in the instruction video and had no luck. What did work was to set the windshield on edge on my carpeted floor and use a rubber mallet to gently tap on the seal to form fit it. That was much easier just be sure to line in up correctly before you strike it so you don't bend the inner metal.