BAMF 3-Way Coax Cable Splitter Bi-Directional MoCA 5-2300MHz

Used these to split a MoCA coax feed to several boxes. We have a Comcast router+modem, and so we have this splitting the street and 2 Hitron MoCA boxes to the MoCA-enabled router. It worked phenomenal and gives us gig-speed speeds over the Moca line and feeds our router at the same time.Advice with this product:- If you do a similar setup remember THE ROUTER CABLE MUST BE ON THE INPUT PORT, NOT YOUR STREET CABLE. When i did this wrong, the router did not connect to the internet.- P.S- Don't forget the line filter to stop the signal from reaching your neighbor's houses.

These splitters are excellent professional quality devices. I recommend them for anyone using catv, dtv, cctv, satellite, etc. The only reason I didn't give 5 stars is because the grounding screws are so small and pathetic that they look like wristwatch parts, making it impossible to connect any ground wire larger than about 26 awg. However, there are two large holes on each side for mounting screws where a proper sized ground wire (12-14 awg) can easily be connected (you will need to provide the screws, washers, etc yourself however).

I installed this on my hub outside of my house and at first I didn't think it was working because my Moca Adapters weren't linking. I had comcast techs come out three times to check the wiring and make sure there wasn't an oddball amplifier or something throwing it off. The last tech actually removed the splitter and told me it wouldn't work with comcast. After the final tech came out, I was about ready to give up and return everything until I decided to change out all of the coax cables. Turns out I just had a bad coax cable the whole time. It's a shame comcast techs don't know what they're doing. That or they feign ignorance to sell more crappy products.Long story short, the splitter works perfect.

Well built splitter that works as advertised. It doesn’t come with the screw for attaching a grounding to the splitter (necessary if you are splitting the coax cable when it first enters the home). The screw hole for the grounding wire is threaded for 4-40 machine screws (you can buy them at Home Depot or on Amazon dirt cheap).

Negligible loss of signal from this and the same one that is 2 way. I tried the 2 way first, and then the 3 way. Almost no difference in the signals when comparing the 2.And compared to no split, just a little loss. These let my OTA antenna amp get power. The splitter that the cable company left did not work with the amp. These products are great. I don't see how any other splitter could be better than these... I highly recommend them. Note: After splitting, I was able to move my amp power inserter to a spare TV and improved my signal strength on my main TV even more.

It's a splitter. It works. Actually, I chose this splitter because it works at the frequencies that allowed the use of MOCA adapters to enable me to use the house's coaxial cable system in lieu of Ethernet cabling to hardwire some WiFi mesh network nodes for wired backhaul.

This magical device saved my marriage and made my child love me again! A few days ago, we suddenly and unexpectedly had no TV signal right at the end of Dancing with the Stars. I was happily reading my book when wife and daughter came to me near tears! The TV wasn't working!I found this to be really strange as our TV antenna had been pulling in broadcasts without interruption for over two years since we got rid of cable. I checked everything along the way, and all seemed to be in working order, but I looked at the old coax splitter that was between my wonderful antenna on the roof and the TV. This thing came with the house and has gone through multiple satellite providers and cable TV connects and disconnects. Scattered on the ground were it's discarded brethren, left to rust in the weather after being replaced by uncaring contractors or an uncaring service provider.Hoping for an easy fix, I dutifully drove to Target in pouring rain in search of a replacement splitter. Alas, one was not to be found, so home to Amazon where I found this splitter's little brother (only a two way splitter) marked as "Amazon's Choice." Hope filled me, and I searched for a 3-Way splitter made by BAMF Manufacturing, and to my delight they made one!One order and paitiently waiting for Prime shipping, and absolute success! The old splitter and it's fallen brethren have been tossed into the rubbish bin, and we have TV signal again. In fact, according to the revered TiVo's signal meter, we have a significantly stronger signal than we had before!Thank you BAMF Manufacturing! If your device could exist on a pedestal next to our TiVo we would display it there with pride!

Worked very well and I like it's a little more compact then some of the other options. All three TV's that are on this 3 way are on digital PVR boxes and none have had any issues with artifacting or loss of signal. When I was talking to the cable provider to activate a new digital PVR box I asked him the signal levels that each was reporting on his end and he said they were all reporting very high signal strength. Seems like a great splitter!