QFS Fuel Pump Strainer - 3 Pack Replacement for Polaris, Ranger, RZR Vehicles 2011-2022

I bought a used RZR 900 and had an issue with bogging when it was warm. Had to fix spark plug issue with the iridum plug heat range 9 being too cold of a plug and fouling along with the cap that screws off was stuck in the plug boot. Got that out with a m4x0.7 thread pitch bolt I think was 35mm long.Oil level was a little low.Still had issue and fuel pressure was in spec at 45.5psi spec according to factory service manual is 43.5psi +/- 2psi. However the pressure would drop down to about 20 psi is where it would hold and pump sounded weak. Replaced the whole pump assembly as it was likely combination of the regulator failing and pump getting old. New pump after primed, took to 3rd key on/off, went to 45.5psi and held within a few (2 or 3) psi and the engine runs so much better overall. I get better fuel milage as well somehow. All the power is restored and I had it out for a good rip all over and it does so much better. Issue of bogging is now completely gone.I used a angled prybar ad flat as I could get it and tapped it to remove the old hold down lid and it came with new lid and gasket. I used same method to tighten the new cap.

Worked great on my 2011 polaris rzr 800 s. I had a hesitation issue with loss of power and this fixed it runs great now with plenty of power...... I think this is a cheaper alternative then buying the assy with sending unit also feel this pump is prob of better quality then of the ones that come in the fully assembled units, the only downside is this requires a bit of work to install. comes with all hardware required to install it. with time patience few tools along with some online vids showing how to do it prob something most could handle. Watch a few vids on how to replace the pump separately to see if this is something your comfortable with. Definitely recommend as a cheaper alternative and would use again should the need come around for mine or someone needing one. It's been installed for a few weeks no issues, long term I can not say how it will do but feel confident no issues will occur.

Pump quit after 5 hours of use, easy install but who cares if you have to redo it every five hours.

I had the typical factory intermittent fuel pump, ordered this pump even though Amazon said it doesn't fit it was obvious it does, it took less than an hour to remove the old one and replace with the new pump. It comes with crimp connectors for the electrical, I took the few extra minutes and soldered and shrink wrapped my connections, installed the pump, hit the key and it fired right up! Top notch company with solid product that even arrived a couple days early.

I liked the fact that they included electrical connections for the fuel pump. It made it much easier than melting the original solder joints. All in all the project wasn't to difficult.

Pump worked and fit great. Way cheaper route then oem and comes with everything u need. I installed on a 2012 rzr 800s

Straightforward install on my 2017 scrambler 850. Did have to cut and wire in the new pump, but that was by far the easiest part of the replacement. My bike immediately fired up and was running better. Interested to see longevity.

I was excited for this pump. I installed it and was disappointed that it didn’t fix my problem, I thin the pump wasn’t pumping enough or something BUT I emailed them and asked them for a refund, they wanted to send me another one but I said I’d rather have a refund and they gave it in full! So happy!