PROHEAR FEP01 Replacement Foam Ear Pads (Upgraded) for 3M WorkTunes Connect(90543, 90544, 90542, 90541,90507), ZOHAN EM042 Radio Headphone （037,027,033） (fep01 2 Pair)

Perfect fit for my torn and rotted pads on my Worktunes. Easy application

The original foam ear protectors had worn completely. Foam was falling out. I ordered these and they fit perfectly. Headphones are like new again.

Some where I read that these were thicker than the original, that is not the case for me they are the same thickness as far as i can tell they work the same. Installation was simple the old ones just popped off and i cleaned the surface off with some warm soapy water and stuck the new ones on time will tell how long they will last but they were cheap enough. ( ordered the four pack, 2 pair)

They are the correct dimensions for my 3M Worktunes radio and bluetooth 90542-3DC, but do not easily snap in place. They do easily come off though, because the 8 sort of tabs are small and don’t grip well. There is a piece of plastic that goes between the actual pad and the earphone speaker.The easiest to use replacement would be one that was already attached to an included plastic frame. The plastic frame is fairly easy to snap in, and stays on very well. I asked in the product listing question section for a glue recommendation. If the seller provides a good recommendation, I will probably glue them.One other thing a out these is that based on the picture I kinda thought these would be made of a more dense and durable foam, like the blue kind I have seen used around swimming pools. But this is similar to the original, a thin plastic over a lightweight foam, similar to the old ones in my photos. I would like them much better if I thought these would last longer than the original padding which disintegrated over the course of a few summers in my garage in Austin, Tx. The garage probably doesn’t get over 110 degrees fahrenheit. At this price I would hope for something that could take that heat, but I doubt these will. So these are an ok option, assuming I find a glue that will hold, but still be replaceble.

I like the second pair included. They work well.

Exact fit. Didn't need adhesive. Snaps right on.

They fit perfectly and offered more cushion then ones I removed. I can wear my headphones longer as they no longer hurt my head.

They look good and do work well.

Needed this to replace the ear pads on an very old noise cancelling headphones. This did the job as I didn't need anything very expensive.

It was like a crap soot weither they would work or not.

Pas tout a fait identique, mais ça fait la job!