Performance Tool W80652 Steering Wheel Puller for Tilt or Telescoping Columns in GM, Chrysler, and Ford Cars and Trucks

For any review that says it broke on them. They used it wrong.. do not remove the first pin all the way until you have the 2nd started. It will pit too much pressure on the only one left and not be able to remove resulting in the tool breaking off. Take one out and tap back in about half way than switch to other side get that one to about the same. Than can remove both. Learned the hard way... but one I left the other one half way in the other came out no issue.

Very nice tool with no concerns

If you need a solution for a problem this is not your tool. Very cheap material and broke within seconds of attempting to remove pivot pins. Very bad

Needed to do what it did ti remove tilt column pins, but tool is very small and weak, probably won't last but a few times. Cheap enough to replace, I suppose, but im from the school that good tools should last a lifetime.

Works great, I used it on my OBS Chevy, and no OBS does not mean something bad. Ha ha 🤣 😂.Old body Style.

I shred through these like there's no tomorrow but I like em.

It works well, also, you don't use it as it's assembled, they actually threaded a hole in the side of the cap to retain all the hardware, ingenious! Plenty of videos out there showing you how to use it properly, just google gm saginaw tilt pin removal.

This item pulled one pin and it stripped it's threads on the second one. Not well made

Bien livré avec soin merci !

Worked perfectly

L’outil est bien conçu pour une colonne de direction inclinable Workhorse mais socle d’appui est trop large et s’évase quand on met de la pression. J’ai dû le refermer pour qu’il s’appuie correctement sur les rondelles. Et le boulon est de mauvaise qualité; les filets se sont arrachés à la première pression. J’ai dû le remplacer par un boulon de qualité et alors, l’outil a bien fonctionné sans effort!

Puller works great did my steering column with no problems.

I’m a little disappointed that first time I used it the 8x32 thread piece broke in the pivot pin and because the pin is hardened it could not be drilled out. I pretty much had to destroy the column to remove the pivot pin… take care when using.