1/2" Carbide Square End Mill, HRC 45 Deg Single End 4 Flute AlTiN Coating Mill Bits

I bought this end mill to replace a POS, HHS end mill. I didn't want to spend a lot so I selected this end mill. There where a lot of these that where way more expensive. But I desided to give this one a chance. So far so good this end mill has performed flawlessly and has milled 3 or 4 times more than the HHS end mill. So I would say that this is well worth the purchase.

Worked as intended.

Works great

Needed to mill a fair bit of alloy steel. Wish I knew the material hardness for reference, but my quality 8% cobalt HSS end mills were not handling it well and they were dulling. So far this carbide end mill has handled a fair amount of cutting like a champ. Clean surface finish on parts, tool is still very sharp and AlTiN coating still looks good.

Worked great!

The media could not be loaded. Excellent price for a solid carbide 1/2” end mill. For around the same price you can get one double ended but shorter cutting depth. Plunged just fine for being a 4 flute

I regularly use these bits in my router table because they cut so cleanly and effortlessly. They are sharp because they are intended to be used as metal cutting bits. So as I use them for woodworking I can’t imagine them not lasting virtually forever with a little care.

was not as advertised, Length Of Cut was not right.