Yukon Hardcore Locking Replacement Hub Dana 60 Front 8 x 6.5" Pattern

Although the picture shows 5-lug, these are 8-lug. It fit my 1993 Dodge W250 with a kingpin Dana 60. The only complaint as another mentioned is the tolerances on the lug stud holes are VERY tight. I usually drive these in with an air chisel, but it wouldn’t even do it. I had to pull them through with an impact and lug nut. Even that way was tough. Otherwise a good buy.

They are machined well except for the outer hub where the locking hub bolts on. The inner ring where the circlip holds the hub internals in is too far from the face of the hub where the outer hardcore locking hub mounts. As soon as you tighten the locking hub 6 screws to torque you can no longer turn the hub from lock to free or vice versa. I've had it apart 5 times on the one side and it's the same result every time. I had to leave the screws a little loose to allow it to mostly work.The only thing that could be done is to machine the outside face down.This was only on one side however as the other works perfectly fine.

I bought this product for my 1975 W200 Dodge Power Wagon. This product will work on a Dodge truck but you can’t use the factory Dodge rotors. The factory rotors are not tall enough so the break lining won’t fit. If your putting these on a Dodge you need to buy mid 80’s Chevy one ton rotors. They are also approximately .300” thicker so you will be pleased with the upgrade. Another thing is your wheel will also be offset out by the same .300”.