CECIndustries EF32RL Flasher

Worked great fixed my issue with my led upgrade flashers work like they should now.

This thing works great! I tried it on incandescent bulbs, a combination of incandescent and LED, and all LED on my 1965 Corvair. It works as advertised in all cases. A couple of things of note: I had to switch the leads on the GM factory flasher socket to get the polarity right. If it's not, the flasher won't work. This is not a difficult task, as the connectors can be removed from the socket if you use a very small screwdriver to release them. Secondly, it is necessary to connect the ground wire to a good ground. I replaced the existing wire end with a larger one that fit the factory ground screw on the steering wheel bracket and it works perfectly. Finally, as noted in another review, it clicks a couple of times after you cancel the turn signal, but who cares. At least the click is audible at an appropriate level. Based on my experience with this unit, if properly installed it works as advertised. I recommend it.

I converted my 1968 Mustang to LED lighting all around. Afterwards, the turn signals would not function. This relay instantly corrected the issue and now my turn signals flash at the correct speed. I'll be ordering another to replace my hazard relay.

Item did not work even though I had it grounded

Worked great right out of the box

I purchased this flasher after converting to LED's and trying a different brand of electronic flasher. The other units were silent so hard for me to know that they were actually on. This was one of the few electronic units I could find that had an audible sound so I ordered and installed it. As noted this unit does need the ground pigtail attached in order to operate, and does make a clicking sound when operating. Unfortunately when my Jeep is running it is too faint for me to hear it. This unit does operate well and does the job. I just wished it was a bit louder where I could hear it better.

If you are converting your older turn signal lights to LEF you need this great breaker. It allows the turn signals to flash whereas if you do not change the flasher the lights do not draw enough amperage to make your old standard flasher to flash. Simple to install just replace the flasher with this on and ground the wire. Works like a charm. Also not you will need one for the emergency flasher as well.

After fumbling with resistors for weeks, this flasher was all that I needed to convert my classic car to LEDs.

A must if installing LED bulbs to replace the old factory ones

Just as stated. Delivery was a bit long at 7+ days but it flashes my LED signal lights front and rear at a proper rate. Also, it is loud enough that I can hear it in the cab of my '49 Chevy truck. There are no turn signal indicators in the cab so and no reset on the signal arm so it gives me an audible reminder if I leave the turn signal on.

Just got this for my ‘65 Comet and works perfectly! LED signal bulbs front and back flash correctly and bright now. I also like the audible clicking sound. Love it

Unfortunately i waited to long to try this one. A 2$ flasher did the job this 35$ one couldn't. Not too happy

I LOVE THIS THING! I switched my Fiero to Led signal lights and my options were expensive resistors I had to wire in each plug, or plug this this in. It works like a dream. The only negative thing I would say is that it is loud. Much louder then the stock unit. It doesn't both me, but if you want a quiet cabin please keep this in mind.