Champion Cutting Tool CorpCircular Saw Blade 14", 64T (RZR-14-64-S)-Cut Steel, Platinum

You need to be careful with any of these blades as you can chip or break if you use to much pressure and if you don't use enough, you will work harden the material. So with the appropriate pressure that I would say is enough force that it cuts smoothly but doesn't start bouncing off the teeth it works great. We cut 160 pcs of 3" square .12 wall tubing with very little effort. The blade is defiantly duller then when we started, but Id say there are at least another 50 or so in it before it will need sharpening. Id for sure buy it again.All in all very happy! Cuts were straight and no one broke it or chipped it.

Best blade I’ve found so far from stainless. Feed rate seems to wants to be slower than the other blades with less teeth, but this other blade kept breaking teeth. I have not had that happen with this blade. I’ve made several cuts in stainless steel pipes (16 gauge) and it’s still very sharp and no teeth missing and it cuts very smooth with very little if any burrs. Worth the extra money in my opinion. I’ll probably buy this blade again over the cheaper alternatives .

This blade started out cutting the stainless steel sheeting (16 gauge) very smoothly and with no issue. However, I had my saw set to full depth which caused the saw to grab the thinner sheet at too obtuse of an angle chipping one of the teeth. As I continued to use the blade, it worked well for a while, but began chipping more teeth even though I had the blade set at a good depth. Be sure not to set the blade too deep.

I don't know what the difference is between this blade and the similar saw blades but this one lasts 5x as long as the longest lasting one I've been able to find up until now. (Evolution) There's no going back.

This is my second sawFirst lasted one yearWas cutting everythingUnistrut, Pipe, Stainless steel, rebar,Very good quality long lasting saw for the moneyMy favorite blade for Makita saw!!!

Only use these blades, now. Get the right blade for your material, and use the right force/speed, and you’re good for tons of cuts.Don’t cut carbon steel with the stainless balde and vice versa...the shape of the blades for stainless doesn’t lend itself to carbon steel, even though it can take the hardness, no sweat, the carbon steel dowsn’t react well to the shape...aluminum blade is butter on aluminum up to 1/4”, for me.These folks did their research.Home fabricator who buys the correct tool for the job, and used the other brands, too.Using Metal Devil 14” metal saw

After destroying a mild steel-cutting blade by cutting stainless steel with it, I tried this blade. Cut through stainless steel as if it were hot butter. Did a great job. Only negatives are that it should come with various bushing adapters to fit more saws. It would be nice if it came with a storage case as some blades are now coming with. Also left a small sharp edge which was easily filed down. Overall a great blade.

I was very disappointed with my Milwaukee m18 metal saw. The OEM blade lasted for 8 linear ft of 3/16 mild steel plate before all teeth were damaged or missing. This blade changed everything. Very clean cuts, the saw motor doesn’t bog, and the blade’s teeth look new after making numerous cuts through steel plate.

Couper aluminium et fonte puls de dents

El disco oem fue un asco no duró absolutamente nada y el precio es absurdo, este disco corta facil soleras 3/16 de placa y se fue como cuchillo caliente en mantequilla espero q valga la pena x el costo elevado y no salga como el Milwaukee q es absurdo su precio y no sirve