Camco Camper / RV AccuLevel - Features Front to Back / Side to Side RV Leveling

These brackets worked well with my bubble level. Even though it was a different brand it still fit well. Good sturdy metal brackets....should last a long time. Delivered right on time.

This is the second fifth wheel that I have used these brackets to mount the matching level on. It's so much easier to see how level the camper wheels are when I pull into a campsite. It makes setup a breeze.

Ordered these brackets along with the AccuLevel to install on my MorRyde pin-box. All the necessary hardware is included and just four 7/32 holes need to be drilled into the pin-box. Installation took about 15 minutes. Slotted holes allow for adjustments front to back and side to side for level when the AccuLevel is installed. I consider it a required items for install of the AccuLevel for 5th Wheel trailers.

Just put this on my 5th wheel. Took me longer than I thought because I ran into a little trouble. The instructions say to drill a 7/32" hole and use the included self tapping screws. Well as another review stated, those screws are soft and I broke one off. First of all the metal that the hitch is made of is hard and thick. I had a hard time drilling the holes. When I put the one screw in as soon as it bottomed out it twisted off. I had to drill that screw out and put in a smaller screw and a nut on the inside of the hitch. (which is very hard to get to). Anyway, I like the bracket and the AccuLevel. I also bought a pair of Andersen-3604 Camper Leveler and hope this makes it very easy to level my 32" 5th wheel. No more 2x12s!

After reading all of the negative comments about the screws breaking, I decided to drill and tap the holes prior to using the mounting screws. This took a little longer but worked great. Screws and 1/4-20. Drill size is still 7/32.

Ez to install

This mount is required to mount the acculevel on the pin box for a 5th wheel trailer. The instruction say to pre-drill holes with a 7/32 bit. That is way to small. I had to go up to a bit that was .206". Then the included self tapping screws aren't self tapping. They are also a very soft. I had two twist off before they got screwed all the way in. I'll have to go the hardware store now and get a better quality screw. These may have worked if I had went up to a larger bit. Maybe something about .210" to .220" The OD on the threads are .250" and since they don't really have much stress on them a larger staring hole should be just fine.

Ordered these metal brackets to mount The level on the Pin box. I drilled and tapped for a 1/4 inch bolt.

Répond à mes attentes

does the job

as described

Works great

ok