Powerbuilt 3000 Pound Triple Lift Garage Jack, Heavy Duty Vehicle, Truck, Car, Motorcycle, Transmission Lift, 1.5 Ton Capacity, 620622

I have the motorcycle jack from that company that stars with HF. I've loved the two of them I've had and they're a whole lot cheaper. But this really does fit better under my Indian than those lifts. With the sturdiness of a regular jack, this actually fully supports my bike. In fact, in the month or so I've had it, I've had my bike on it muliple times. I had to swap out the wheel bearings and the steering column bearings, and that means removing the whole front fairing. Took me about a week. Zero issues, even leaving the bike up, no extra support or the bracket to keep it up. Currently swapping out the pinion shaft on my Chieftain and that means primary is off and it'll be a couple days before the part arrives. Just hanging out right there in the garage with the bike lifted up. Super easy. Also used it (gotta put that little round piece back in) to lift up the Murano to check the brake pads. Just a great tool. I can now sell my car jack and the HF mc lifts.

Powerbuilt's 2-ton floor jack is a huge improvement over my 3-ton jack which I have been using for the last 10 years plus. Each Fall I annually change out a set of four summer wheels (rim mounted tires) with my set of four winter tires and reverse the wheel set swap again in the Spring. This Fall's swap, with the Powerbuilt floor jack was faster, easier, with more stability, and with better maneuverability (as stated on their web site) than with my old, but trusty, 3-ton jack hands down! I timed this years wheel set swap to be just shy of 30 minutes with everything propositioned. If I had known the difference using Powerbuilt would make to this chore, I would have purchased a Powerbuilt jack year's ago. Bottom line, the Powerbuilt 2-ton jack purchase was made with my safety the main priority! Excellence product, excellent purchase, would buy it again!!

Have only used it a couple times so far but just taking it out of the box you can tell how high quality and durable it is. It’s not very low profile and at its lowest high it just barely fit under the Jetta but if you’re looking for low profile then get a low profile jack. This jack is perfect for most cars, cruisers, dirtbikes, and probably even some small trucks. Very happy with this purchase because I only needed a motorcycle jack and now I have a car jack too, all in one!

It does what it says. A few notes:- The round saddle is slightly higher than the large rectangular flat rails. The saddle part lifts off (no screws, just sitting in a recess) for use with motorcycles, ATVs, etc...- Make sure the flat area isn’t touching something it shouldn’t (e.g. exhaust, anti-roll bars, oil pan) before you lift! It is way bigger than a typical floor jack.- You need to raise the jack quite high to allow the lock bar to be installed. The way I used to swap wheels, I would set the jack stands so that the tires were barely above the floor. Now I’m lifting the wheel and tire well above the floor to get them on and off.- Not needing jack stands is nice. However, since the jack is on wheels too, I bought a set of wheel chocks for the end of the car still on the ground. MLTOOLS Wheel Chocks | 2 Pack High Grip Wheel Chocks | Made in USA WC283The screw that held the handle in the socket was lost during shipping, but the company sent me another one for free.

Good little jack, a bit heavy, but does what it is supposed to. I like the ability to use flat or put the head attachment in to use like a normal floor jack. There are two negatives issues I have with it that prevent a 5 star rating: the locking bar and the handle. The locking ability is only available when the jack is in full extension. You can’t just lock it out at any height, there is only one spot for it to work and that is at full extension. The other bad thing is the handle does not go all the way up (verticle), it only goes up approx 75% of verticle which makes it a pain when trying to jack up (smaller gains per strike compared to a normal floor jack) and also a pain for storage if you don’t want to remove the handle each time you use it (it sticks out quit a bit due to not going verticle)

All I can say is wow! I am very impressed with this jack. At first when the jack arrived in the box at my home one of the wheels have broke threw the bottom. So I was like, well here we go the thing is damaged before I can even use it. So I opened the box and I was just like wow, this thing if a freaking tank! Believe you me that the pictures do not do this thing any justice. I just starred at it for like a few minutes in awe it was so big. So I took it out of the box to inspect for any damage and I must say that this thing is built solid. No damage to the exposed wheel what so ever. Also this jack is extremely heavy so take your time.Well I just used this jack to lift my SUV to change the oil and I must say DAMN! Not only did this jack lift the front passenger side with ease. It also lifted the rear passenger tire of the ground also,once again DAMN! I did not notice that the rear tire was off the ground until I double checked if the tire chocks where still in place which they where, but the tire was not. Now all I can say is WOW I have never owned a jack that did this at all. I am very impressed. If you are on the fence about this purchase. If you where to ask me, I will tell you to pull the trigger on this one you will not be disappointed, I surely was not. Good Luck.