Bright2wheels Led Tail Light Integrated Turn signals for Triumph 97-01 Speed Triple, 97-98 595, 99-01 Daytona 995 smoke Lens Maximum Quantity High Brightness LEDs installed Specific Tail Light for the above-mentioned models, Improve appearance and brightness Fit well like original light without any changes With Built-in Amber Turn Signals Included connectors, resistors or Relays if applicable Warranty: 6 months Installation of Built-in turn signals: Connect the two YELLOW wires to the positive turn signal wires using provided red connectors or alternately use your existing factory connectors. Ground wire is not needed unless you are using resistors to slow down the blinking rate. The ground wire is the same color wire used on both turn signals. To remove the error code on dashboard or slow down the blinking rate use provided resistors if necessary: Wiring Diagram applicable to most bikes: Black Wire(Negative), Green Wire(Brake) Red Wire(Running Light) 1. Connect one end of the resistor to the ground wire on your turn signal harness from your bike. 2. Connect the other end of the resistor to both the YELLOW wire from our taillight and the positive turn signal wire from your turn signal harness from your bike. 3. Repeat the same process for the other side. To use the red connectors, place one wire inside along one channel, place another wire inside along the other channel. Push down the metal pin as it will make a small cut on each wire bridging the connectors. if you are using the resistors, place one end of the resistor in the middle of either channel along with the one wire.
Trustpilot
1 month ago
2 months ago
