Titan AttachmentsUniversal Skid Steer Quick Tach Conversion Adapter Welding

Have yet to install, but looks and feels very solid. Installing on our old 90hp JD 4020 with 148 loader. It feels stout enough to support the claim of 3500# capacity, though our loader is only listed as 3100# capacity so I won't be able to truly test it, though I'm sure my dad will try.As others have mentioned, latch-pin grease fittings will need to be switched out for 90 degree fittings. Tractor-side plates are wider than they appear in the picture and cover the grease zerks with only a couple inch gap between.Bottoms of plates on tractor side will likely need to be cut down a bit for ground clearance with lower profile buckets. Not that big of a deal, considering I need to cut pin mounts off existing buckets and weld them to this adapter anyway. To be expected, to a certain degree, with a universal mount like this.I do not care for the fact that the bottom of the bucket side (where pins latch into bucket) is not angled to fit snugly into the bucket. I haven't decided whether this is actually an issue or not, but will likely weld a little plate on there anyways.For those of you with compacts or sub-compacts, this might be a little too heavy. It will also extend the bucket another 6ish inches compared to pins only.Will update this review if any issues are encountered, but looks like a good deal on a solid QA adapter.

Had to grind the factory welds out to get it to fit up to any attachments. Seemed like it was just thrown together as I had to adjust pretty much everything with the locking pins to get them to work correctly

Color was red.Fairly heavily made and welds were ok.Made it very easy to make my pin on bucket on my John Deere into a Quick Attach system.Did shorten the base as it seemed to stick down too far for my application, but this is an adaptor that has to fit a variety of machines so that was acceptable.I would recommend it to anyone needing a quick fix for their pin on loader.Now, I have a forklift, dirt bucket, and bale spear that I can easily change when I want.

Heavy Duty - well made. The attachment welded directly to the 4200 loader. The only tricky measurement was what height on the loader brackets was needed to make equipment hook-ups that ensured the bucket could lower to the ground and the bottom of the weld plate not hit the ground prematurely. I had to change out the grease zercs on the slide bar of the quick attach to 90 degree zercs vs. the straight out ones that came with it. There is no way to get a regular grease gun on a straight zerc due to the solid metal plate. The attachment shown on line does not have the zercs covered but the one that I received had the back weld plate covering the entire front plate that hooks on the equipment. That also makes it difficult to spot the actual skid steer portion into the equipment properly while driving the tractor. To remedy this I welded a bead on the back plates to show where the edge of the front skid steer plate was located. This way you can determine where you are on the implement from the tractor.

Worked great for my situation. Adapting a obsolete quick attach from Massey to the skid steer. Allows me to use my old tractor on all implements. Looks to be build heavy duty. Answer to a problem I have had for a long time!

Very cheaply made. Every attachment falls off.

Heavy duty, works great. Not for sissy's though. Cutting mounts off your existing bucket and converting it to quick release is tough work. Very rewarding though and when you're done, the quality of this product means you didn't waste your time and knuckles and you've now got a whole world of attachments you can use. Thank you to the folks at Titan.

This is a great accessory for our skid steer